Salecom 12 Button Switch Installation Guide

Button switch installation manual

12 Tlačítkový spínač

Models Involved

Safety Precautions and Preparation Work

Before starting the installation, please read and comply with the following safety regulations carefully:
Provoz při vypnutí
Prior to installation or wiring, ensure that the power supply of the equipment is completely cut off, and take measures to prevent accidental power-on so as to ensure personal safety.
Profesionální instalace
Installation and wiring shall be performed by qualified professional electricians or technical personnel.
Environmentální požadavky
Do not install or use this switch in environments with flammable, explosive or corrosive gases.
Specification Matching
Ensure that the electrical specifications (voltage, current) of the switch match the load requirements of your circuit to avoid overload operation.

Požadované nástroje

Panel hole cutter meeting specifications (not required if the hole has already been drilled)
Open-end wrench or socket wrench

Installation Procedure (Details as Follows)

01 Step One
Panel Hole Drilling(Skip if pre-drilled)

Drill diameter per model specs. Remove hole-edge burrs after drilling to prevent switch scratches or sealing failure.
02 Step Two
Zajistěte spínač

Hold the button head vertically from the front, then tighten the mounting nut by hand from the back of the panel.
03 Step Three
Vložte spínač

Pass the switch body through the hole from the front, then fasten the nut from the back.
04 Step Four
Tighten the Mounting Nut

Align the switch properly, then tighten the nut with a wrench to a moderate torque-secure but not loose. Do not overtighten to avoid thread damage or panel deformation.

Poznámka
Do not directly rotate the base by hand to avoid loosening it.