JoJo Booster Pump Flow Controller
Specifikace
- Název produktu: JoJo Booster Pump Flow Controller
- Kompatibilní s: JoJo Booster Pumps
- Náhradní díl: JoJo PC Board
- Požadované nástroje: STAR SCREW DRIVER
Budete vyžadovat následující:
Poznámka: Our Booster Pump PC Board is only suited for use with the following JoJo
Booster Pumps:
- 0.37kW pomocné čerpadlo
- 0.55kW, 0.75kW & 1.1kW
- Odstředivá čerpadla
- 0.6kW samonasávací tryskové čerpadlo
Návod k použití produktu
KROK 1
Ensure that your pump is disconnected from the power source.
KROK 2
Unscrew the four screws holding the terminal box cover in place.
KROK 3
Sejměte kryt svorkovnice.
KROK 4
Disconnect the wires from the terminals and remove from the terminal box.
KROK 5
Unscrew the two screws holding the PC Board in place.
KROK 6
Demontujte desku PC.
KROK 7
Insert the replacement JoJo PC Board.
KROK 8
Insert and fasten the two securing screws on both sides of the PC Board.
KROK 9
Secure the wires to the terminals as follows:
- the wires from the pump through the bottom grommet
- the wires from the three-point plug through the top grommet.
Poznámka: ensure that the correct color sequence is followed as shown below
KROK 10
Replace the terminal box cover, and fasten the four screws holding it in place.
KROK 11
Your pump is now ready for use and reconnection to your power supply.
Scan the QR Code to watch the instructional video for visual guidance.
FAQ
Can I use the JoJo Replacement PC Board with other pumps?
Our Booster Pump PC Board is only suited for use with JoJo Booster Pumps.
Dokumenty / zdroje
 |
JoJo Booster Pump Flow Controller [pdfUživatelská příručka Booster Pump Flow Controller, Pump Flow Controller, Flow Controller, Controller |