Návod k obsluze RC letadla DEERC Model 9672-US

Zavedení

This manual provides essential instructions for the safe and effective operation, setup, and maintenance of your DEERC RC Plane Model 9672-US. Please read this manual thoroughly before operating the aircraft to ensure proper function and to maximize your flying experience.

Bezpečnostní informace

Warning: Not for Children Under 14. This product contains small parts which may pose a choking hazard. This product is not suitable for individuals under 14 years of age.

• Always operate the RC plane in open, clear areas, away from people, animals, buildings, and power lines.
• Před každým letem se ujistěte, že je baterie plně nabitá.
• Nelétejte za silného větru nebo nepříznivých povětrnostních podmínek.
• Pravidelně kontrolujte letadlo před a po každém letu, zda není poškozené.
• Keep fingers and loose clothing away from propellers when the aircraft is powered on.
• Follow all local regulations and laws regarding RC aircraft operation.

Obsah balení

Ověřte, zda jsou v balení obsaženy všechny níže uvedené položky:

• 1 x RC Plane
• 3 x 7.4V LiPo Batteries
• 1 x nabíjecí kabel
• 1 x Produktový manuál
• 1 x Dálkové ovládání
• 1 set of Landing Gear

Image: The DEERC RC Plane Model 9672-US, remote control, three batteries, and landing gear components.

Nastavení

1. Montáž letadla

1. Install Tail Fins: Carefully attach both tail fins to the designated slots on the rear of the aircraft. Ensure they are securely in place before flight.
2. Attach Landing Gear: Insert the landing gear into the slots on the underside of the plane. The landing gear can be removed for hand-toss launches.

2. Nabíjení a instalace baterie

The RC plane uses 7.4V 20C LiPo batteries. It is crucial to use the provided charging cable and follow safety guidelines for LiPo batteries.

• Connect the battery to the charging cable, then connect the charging cable to a suitable USB power source.
• Indikátor nabíjení bude ukazovat stav nabíjení. Po plném nabití odpojte zařízení.
• Open the battery compartment on the aircraft and carefully insert a charged battery. Ensure the connectors are properly aligned and securely plugged in.
• Zavřete přihrádku na baterie.

Image: Illustration of the 7.4V LiPo battery, highlighting its power output compared to a 3.7V battery.

3. Párování dálkového ovladače

1. Ensure the aircraft's battery is connected and the plane is powered on.
2. Zapněte dálkové ovládání.
3. The remote control and aircraft should automatically pair. If not, refer to the troubleshooting section.

Návod k obsluze

1. Letové režimy

The RC plane features three adjustable flight modes to suit various skill levels and flight preferences:

• Beginner Mode (Mode A): Provides maximum stability and assistance, ideal for new pilots or windy conditions.
• Dynamic Flight Mode (Mode B): Offers a balance of stability and maneuverability for intermediate pilots.
• Freestyle 3D Mode (Mode C): Designed for advanced pilots to perform stunts, 3D flight, and inverted flying with full manual control.

Image: Diagram illustrating the three flight modes: Beginner, Dynamic, and Freestyle 3D, showing the range of control and assistance.

2. Takeoff Procedures

The aircraft supports two takeoff methods:

• Hand Toss Launch: Hold the plane firmly and gently toss it forward into the wind while simultaneously applying throttle.
• Runway Glide Takeoff: Place the plane on a flat, clear surface (with landing gear attached). Gradually increase throttle and steer until the plane gains sufficient speed for liftoff.

Image: Visual representation of the hand toss launch and runway glide takeoff methods for the RC plane.

3. Remote Control Functions and Trim Adjustment

The 2.4GHz remote control provides precise command over the aircraft. Familiarize yourself with the controls and trim adjustments for optimal flight performance.

Image: Diagram of the remote control, indicating the throttle lever, rudder gear, elevator lever, and various fine-tuning (trim) adjustment buttons for left/right turning and head up/down.

Upozornění na vybitou baterii: The remote control will provide a warning when the aircraft's battery is low, indicating it's time to land.

Údržba

• Čištění: Wipe the aircraft with a soft, dry cloth after each use to remove dust and debris. Avoid using harsh chemicals.
• Kontrola vrtule: Regularly check propellers for damage (cracks, bends). Replace damaged propellers immediately to maintain flight performance and safety.
• Péče o baterie: Store LiPo batteries in a cool, dry place, away from direct sunlight and extreme temperatures. Do not overcharge or over-discharge batteries.
• Silicone Guard: The aircraft is equipped with a silicone guard on the nose for impact protection. Ensure it is properly attached.

Image: The DEERC RC Plane featuring a silicone guard on the nose, designed to protect against impacts.

Odstraňování problémů

• Letadlo nereaguje: Ensure both the aircraft and remote control are powered on and batteries are charged. Re-pair the remote control if necessary.
• Špatná letová stabilita: Check for damaged propellers or control surfaces. Ensure the six-axis gyro is functioning correctly (refer to remote control instructions for calibration if available).
• Krátká doba letu: Ensure batteries are fully charged. LiPo batteries have a limited lifespan and may need replacement over time.
• Obtížnost při vzletu: Verify sufficient thrust by checking motor function. Ensure you are using the correct takeoff method for your environment (hand toss for smaller spaces, runway for larger).

Specifikace

Image: The DEERC RC Plane with its key dimensions: 18.50 inches length, 12.8 inches width, and 1.97 inches height.

Záruka a podpora

DEERC provides comprehensive after-sales service and a quality guarantee for this product. If you encounter any issues or require assistance, please contact DEERC US customer support. Details for contacting support can typically be found on the product packaging or the official DEERC webmísto.

The product is sold by DEERC US and fulfilled by Amazon, ensuring reliable service and support channels.