BLACK+DECKER BXGNP6510E 6500W Gasoline Generator

1.1 Vybalení a počáteční kontrola

Carefully remove the generator from its packaging. Inspect for any damage during transit. Ensure all components listed in the packing list are present.

• Generátorová jednotka
• Klíč na zapalovací svíčku
• Nálevka na olej
• Šroubovák
• EU plugs
• Protiprachový kryt
• USB adaptér

1.2 Umístění a větrání

Place the generator on a firm, level surface. Ensure adequate ventilation around the unit to prevent overheating and to disperse exhaust fumes. Do not operate indoors or in enclosed spaces.

1.3 Doplnění motorového oleje

Before first use, the engine must be filled with oil. The oil capacity is approximately 0.6 liters. Use SAE 10W-30 engine oil. Do not overfill.

Obrázek: Boční view of the generator, highlighting the engine area for oil filling.

Video: Demonstrates how to change the oil in a similar generator model. Follow the instructions in this manual for specific oil type and capacity.

1.4 Doplnění paliva

Fill the fuel tank with unleaded gasoline (E10 compatible). The fuel tank capacity is 33 liters. Do not overfill and ensure the fuel cap is securely tightened.

Obrázek: Nahoře view of the generator, showing the fuel cap for filling.

Video: Demonstrates the process of adding fuel to a similar Black+Decker inverter generator. Ensure to use the correct fuel type and capacity as specified in this manual.

1.5 Připojení baterie

Connect the battery terminals, ensuring correct polarity (red to positive, black to negative). Secure the connections firmly. The generator includes a sealed lead-acid battery.

Obrázek: Boční view of the generator, showing the battery location.

2.1 Spuštění generátoru

Ujistěte se, že generátor stojí na rovném povrchu a že všechna připojení jsou bezpečná.

1. Otočte palivový ventil do polohy „ON“.
2. Přesuňte páčku sytiče do polohy „SYTIČ“ (pokud je motor studený).
3. For electric start: Insert the key into the ignition and turn it to the 'START' position. Release once the engine starts.
4. For manual start: Pull the recoil starter handle firmly until the engine starts.
5. Jakmile motor nastartuje, pomalu přesuňte páčku sytiče do polohy „RUN“ (chod).

Obrázek: Zadní view of the generator, showing the control panel with ignition and outlets.

2.2 Připojení elektrických zátěží

After the generator has started and stabilized, you can connect your electrical appliances. Ensure the total wattage of connected devices does not exceed the generator's rated output (6000W nominal, 6500W maximum).

2.3 Zastavení generátoru

1. Odpojte všechny elektrické zátěže od generátoru.
2. Otočte spínač motoru do polohy „VYPNUTO“.
3. Otočte palivový ventil do polohy „VYPNUTO“.

3.1 Regular Maintenance Schedule

3.2 Výměna motorového oleje

To change the engine oil, ensure the engine is warm. Place a suitable container under the oil drain plug. Remove the oil fill cap and the drain plug to allow the oil to drain completely. Reinstall the drain plug and refill with fresh SAE 10W-30 oil to the upper mark on the dipstick. Securely replace the oil fill cap.

Video: Demonstrates the process of changing engine oil in a similar generator model. Refer to this manual for specific oil type and capacity.

3.3 Čištění vzduchového filtru

Remove the air filter cover and take out the foam filter element. Wash the filter element in warm, soapy water, rinse thoroughly, and allow it to air dry completely. Apply a few drops of clean engine oil to the filter, then squeeze out any excess. Reinstall the filter and cover.

Obrázek: Boční view of the generator, showing the air filter cover.

Video: Demonstrates the process of cleaning the air filter in a similar generator model.

3.4 Kontrola a výměna zapalovací svíčky

Remove the spark plug cap and use a spark plug wrench to remove the spark plug. Inspect the electrode for wear or carbon buildup. Clean or replace the spark plug as necessary. Ensure the gap is correct before reinstalling. Tighten the spark plug securely and reattach the cap.

Video: Demonstrates the process of replacing the spark plug in a similar generator model.

3.5 Fuel System Draining for Storage

For long-term storage, it is necessary to drain residual fuel from the carburetor. Turn the fuel valve to 'ON'. Loosen the drain screw on the carburetor bowl counter-clockwise to drain the fuel into a suitable container. Once drained, tighten the screw clockwise.

Video: Demonstrates the process of draining residual fuel from the carburetor for storage in a similar generator model.

3.6 Dlouhodobé skladování

After draining the fuel system, clean the exterior of the generator. Store it in a clean, dry, and well-ventilated area, away from direct sunlight and extreme temperatures. Cover the generator with a dust cover to protect it from dust and moisture.

4.1 Běžné problémy a řešení

5.1 Technické údaje

• Nominální výkon: 6000W
• Maximální výkon: 6500W
• Motor: Dvoutaktní, 420 cm4
• svtage: 230V
• Kapacita palivové nádrže: 33 l
• Hladina hluku (ve 7m): 71 dBA
• Autonomy (50% load): 11 hodin
• Rozměry: 78 x 65 x 62 cm
• Hmotnost produktu: 88 kg
• Typ baterie: Uzavřená kyselina olověná

Image: Generator dimensions for reference.

6.1 Informace o záruce

This product is covered by a manufacturer's warranty. Please refer to the warranty card included with your purchase for specific terms and conditions. Keep your proof of purchase for any warranty claims.

6.2 Zákaznická podpora

For technical assistance, spare parts, or service inquiries, please contact your authorized BLACK+DECKER service center or the retailer where the product was purchased. Provide your model number (BXGNP6510E) and serial number when contacting support.