Duravit D-Neo 25-11/16" Rectangular Ceramic Wall Mounted Bathroom Sink

1. Úvod

This instruction manual provides essential information for the safe and proper installation, operation, maintenance, and troubleshooting of your Duravit D-Neo 25-11/16" Rectangular Ceramic Wall Mounted Bathroom Sink (Model: 2367650000). Please read this manual thoroughly before beginning installation or use, and retain it for future reference.

Figure 1: Duravit D-Neo Wall Mounted Bathroom Sink. This image shows the white ceramic sink with a pre-drilled single faucet hole, a chrome faucet installed, and a pop-up drain.

2. Bezpečnostní informace

Please observe the following safety precautions to prevent injury and property damage:

• Před zahájením jakékoli instalace nebo údržby vždy uzavřete hlavní přívod vody.
• Během instalace používejte vhodné osobní ochranné prostředky (OOP), jako jsou ochranné brýle a rukavice.
• Ensure the wall structure is capable of supporting the weight of the sink when filled with water. Consult a qualified professional if unsure.
• Handle ceramic products with care to avoid chipping or breakage.
• Do not use harsh chemicals or abrasive cleaners on the sink surface, as this may damage the finish.
• Ujistěte se, že všechna spojení jsou vodotěsná, aby nedošlo k únikům.

3. Obsah balení

Před zahájením instalace ověřte, zda jsou všechny komponenty přítomny a nepoškozené:

• Duravit D-Neo Ceramic Wall Mounted Bathroom Sink (Model: 2367650000)
• Mounting Hardware (screws, anchors, brackets as supplied by manufacturer)
• Installation Template (if provided)

Note: Faucet, drain assembly, and P-trap are typically sold separately and are not included with the sink unit.

4. Pokyny k instalaci

This section outlines the steps for installing your wall-mounted bathroom sink. Professional installation is recommended.

4.1 Potřebné nástroje a materiály (nejsou součástí balení)

• Drill and drill bits suitable for wall material
• Úroveň
• Měřicí páska
• Tužka
• Nastavitelný klíč
• Sada šroubováků
• Sealant (silicone caulk)
• Faucet, drain assembly, and P-trap

4.2 Kroky před instalací

1. Inspect the Sink: Carefully unpackage the sink and inspect it for any damage. Do not install a damaged sink.
2. Vypněte přívod vody: Locate and turn off the main water supply to the bathroom.
3. Připravte zeď: Ensure the wall where the sink will be mounted is structurally sound and clean. Reinforce if necessary.

4.3 Mounting the Sink

1. Určete montážní výšku: Standard rim height for bathroom sinks is typically 31-34 inches (79-86 cm) from the finished floor. Refer to local building codes for specific requirements.
2. Označte montážní body: Using the provided template (if applicable) or by carefully measuring the sink's mounting holes, mark the precise locations on the wall for drilling. Use a level to ensure accuracy.
3. Vrtací otvory: Drill pilot holes at the marked locations, ensuring the drill bit size is appropriate for the wall anchors/mounting hardware.
4. Install Anchors/Brackets: Insert wall anchors into the drilled holes. Secure any mounting brackets or studs into the wall according to the hardware manufacturer's instructions.
5. Mount Sink: Carefully lift the sink and align its mounting holes with the installed hardware. Secure the sink to the wall using the provided screws or bolts. Do not overtighten, as this can crack the ceramic. Ensure the sink is level and firmly attached.

Obrázek 2: Nahoře View Technical Drawing. This diagram illustrates the top-down dimensions of the sink, including width (650mm / 25 5/8"), depth (480mm / 18 7/8"), and faucet hole placement. All measurements are in millimeters and inches.

Obrázek 3: Strana View Technical Drawing. This diagram shows the side profile dimensions of the sink, including height (165mm / 6 1/2") and recommended installation heights for plumbing connections. All measurements are in millimeters and inches.

Figure 4: Alternative Side View Technical Drawing. This diagram provides additional side profile dimensions and plumbing connection heights, which may vary based on specific installation requirements. All measurements are in millimeters and inches.

4.4 Faucet and Drain Installation

1. Nainstalujte faucet: Follow the manufacturer's instructions to install your chosen single-hole faucet into the pre-drilled faucet hole on the sink. Secure it firmly.
2. Instalace odtokové sestavy: Install the pop-up drain assembly into the sink's drain opening, ensuring a watertight seal with plumber's putty or silicone sealant as recommended by the drain manufacturer.
3. Připojení vodovodního potrubí: Connect the hot and cold water supply lines to the faucet. Use an adjustable wrench to tighten connections, but do not overtighten.
4. Connect P-Trap: Connect the P-trap to the drain assembly and the wall drain pipe. Ensure all connections are hand-tightened, then use a wrench for a final snug fit.

4.5 Závěrečné kroky

1. Zkontrolujte netěsnosti: Slowly turn on the main water supply. Open the faucet and allow water to run for a few minutes. Carefully inspect all water connections (faucet, supply lines, drain, P-trap) for any signs of leaks. Tighten connections as needed.
2. Okraje těsnění: Apply a bead of silicone sealant along the back edge of the sink where it meets the wall to prevent water from seeping behind the unit. Smooth the sealant for a clean finish.

5. Provoz

The Duravit D-Neo sink is designed for standard bathroom use. Once properly installed and connected to a water supply and drain, operate it as follows:

• Průtok vody: Use the faucet handle(s) to control the flow and temperature of water.
• odvodnění: The sink features a standard drain opening. If a pop-up drain assembly is installed, use its mechanism to open or close the drain for filling or emptying the basin.

6. Údržba a péče

Proper care will ensure the longevity and appearance of your ceramic sink.

• Pravidelný úklid: Clean the sink regularly with a soft cloth or sponge and mild, non-abrasive soap or ceramic cleaner.
• Vyhněte se agresivním chemikáliím: Do not use abrasive cleaners, scouring pads, strong acids, alkalis, or chemical drain cleaners, as these can damage the ceramic glaze.
• Otírejte do sucha: After cleaning, wipe the sink dry with a soft cloth to prevent water spots and mineral buildup.
• Zabraňte poškrábání: Avoid dropping heavy or sharp objects into the sink, which could chip or scratch the ceramic.

Pokyny k péči o výrobek: Otřete suchým hadříkem.

7. Řešení problémů

V této části naleznete běžné problémy a jejich možná řešení.

If you encounter issues not listed here or if solutions do not resolve the problem, please contact customer support or a qualified plumber.

8. Specifikace

9. Informace o záruce

The Duravit D-Neo 25-11/16" Rectangular Ceramic Wall Mounted Bathroom Sink (Model: 2367650000) is covered by a 5 rok omezená záruka od výrobce.

This warranty typically covers defects in material and workmanship under normal use and service. Please retain your proof of purchase for warranty claims. For full details regarding terms, conditions, and limitations of the warranty, please refer to the official Duravit warranty documentation or contact Duravit customer service.

10. Zákaznická podpora

For technical assistance, replacement parts, or warranty inquiries, please contact Duravit customer support:

• Výrobce: Duravit
• Webmísto: www.duravit.us (or your regional Duravit webweb)
• Kontaktní údaje: Refer to the official Duravit website for the most current contact details, including phone numbers and email addresses for your region.

Při kontaktování podpory mějte prosím po ruce číslo modelu produktu (2367650000) a doklad o koupi.