LASCO 24V Heat Only Thermostat

White Rodgers 24V Heat Only Thermostat Instruction Manual

Model: 24V Heat Only Thermostat

1. Úvod

This manual provides comprehensive instructions for the installation, operation, and maintenance of your White Rodgers 24V Heat Only Thermostat. This device is designed to control heating systems by maintaining a desired temperature within a range of 50 to 90 degrees Fahrenheit (10 to 32 degrees Celsius). Please read these instructions carefully before proceeding with installation or operation to ensure safe and efficient use.

2. Bezpečnostní informace

Vždy dodržujte následující bezpečnostní opatření:

  • Elektrické nebezpečí: Disconnect power to the heating system at the main fuse or circuit breaker panel before installing or servicing the thermostat. Failure to do so may result in electrical shock or equipment damage.
  • svtage Kompatibilita: This thermostat is designed for 24V heating systems only. Do not use it with line voltage (120V or 240V) systems.
  • Profesionální instalace: If you are unfamiliar with electrical wiring, it is recommended to have a qualified electrician or HVAC technician install this thermostat.
  • Správná likvidace: Dispose of old thermostats and packaging materials according to local regulations.

3. Instalace a nastavení

Pro správnou instalaci postupujte podle následujících kroků:

3.1 Místo montáže

Install the thermostat on an inside wall, approximately 5 feet (1.5 meters) above the floor. Avoid locations:

  • Near windows, outside doors, or vents.
  • Near heat-generating appliances (e.g., televisions, lampledničky).
  • In direct sunlight or areas with poor air circulation.

3.2 Zapojení

Before wiring, ensure power to the heating system is OFF.

  1. Remove the cover of the old thermostat and note the wire connections. Typically, a heat-only system will have two wires: 'R' (power) and 'W' (heat call).
  2. Disconnect the wires from the old thermostat.
  3. Mount the new White Rodgers thermostat base to the wall using the provided screws.
  4. Connect the 'R' wire to the 'R' terminal and the 'W' wire to the 'W' terminal on the new thermostat. Ensure connections are secure.
  5. Nasaďte kryt termostatu.

3.3 Počáteční zapnutí

Restore power to the heating system at the main fuse or circuit breaker panel. The thermostat is now ready for operation.

White Rodgers Heat Only Thermostat with temperature dial and OFF/ON switch

Obrázek 1: Přední view of the White Rodgers Heat Only Thermostat. The upper slider controls the OFF/ON function, while the lower slider sets the desired temperature, indicated in both Fahrenheit (50-90) and Celsius (10-32).

4. Návod k obsluze

The White Rodgers Heat Only Thermostat features simple manual controls.

4.1 Řízení výkonu

The upper slider on the thermostat controls the power to the heating system:

  • Přesuňte se do VYPNUTO: Disables the heating system.
  • Přesuňte se do ON: Enables the heating system to operate based on the set temperature.

4.2 Nastavení teploty

The lower slider on the thermostat is used to set your desired room temperature:

  1. Ensure the upper slider is set to ON.
  2. Move the lower slider to the desired temperature setting. The scale indicates temperatures in both Fahrenheit (50-90°F) and Celsius (10-32°C).
  3. The heating system will activate when the room temperature falls below your set point and will turn off when the room temperature reaches or exceeds your set point.

5. Údržba

This thermostat requires minimal maintenance.

  • Čištění: Pravidelně otírejte vnější část termostatu měkkým hadříkemamp tkanina. Nepoužívejte abrazivní čisticí prostředky nebo rozpouštědla.
  • Odstranění prachu: Gently remove any dust accumulation from the vents or internal components using a soft brush or compressed air. Ensure power is off before cleaning internal components.
  • This model does not require battery replacement as it is a mechanical, 24V wired thermostat.

6. Řešení problémů

If you encounter issues with your thermostat, refer to the following table:

ProblémMožná příčinaŘešení
Žádné teplo
  • Thermostat set to OFF.
  • Teplota nastavená příliš nízko.
  • Spálená pojistka nebo vypnutý jistič.
  • Uvolněné vedení.
  • Porucha topného systému.
  • Set thermostat to ON.
  • Zvyšte nastavenou teplotu nad pokojovou teplotu.
  • Zkontrolujte a vyměňte pojistku nebo resetujte jistič.
  • Check wiring connections (ensure power is OFF).
  • Contact an HVAC technician.
Nepřesný údaj o teplotě
  • Umístění termostatu ovlivněno průvanem nebo zdroji tepla.
  • Hromadění prachu.
  • Relocate thermostat if possible, or shield from drafts/heat sources.
  • Clean thermostat (ensure power is OFF).
Heating system runs continuously
  • Termostat nastavený příliš vysoko.
  • Porucha termostatu.
  • Nižší nastavená teplota.
  • If problem persists, contact an HVAC technician.

7. Specifikace

  • Značka: White Rodgers (Manufactured by LASCO)
  • Model: 24V Heat Only Thermostat
  • svtage: 24 voltů
  • Proud: 1.2 Amps
  • Rozsah teplot: 50 až 90 °F (10 až 32 °C)
  • Typ displeje: Manual Slider
  • Typ ovládání: Button Control (Slider)
  • Podsvícení: Žádný
  • Rozměry: Approximately 20 x 7 x 8.8 inches (Product packaging dimensions, actual unit smaller)
  • Hmotnost položky: 6.4 unce
  • UPC: 786710545658

8. Záruka a podpora

Specific warranty information for this White Rodgers thermostat is not provided in the product details. For warranty claims or technical support, please refer to the contact information provided with your purchase or visit the official White Rodgers webstránky. Uschovejte si doklad o koupi pro případné dotazy týkající se záruky.

Související dokumenty - 24V Heat Only Thermostat

Předview Larsen Supply Co. Ceramic Stems Catalog
Comprehensive catalog of ceramic faucet stems and related repair parts from Larsen Supply Co. (LASCO), featuring detailed specifications, model numbers, and compatibility information for various brands.
Předview Programovatelný termostat Braeburn 2020NC – funkce a specifikace
Podrobné informace o singlech Braeburn 2020NCtagProgramovatelný termostat pro vytápění/chlazení, konvenční nebo tepelné čerpadlo, včetně funkcí, architektonických a produktových specifikací a kompatibility.
Předview White Rodgers 1F79 Non-Programmable Heat Pump Thermostat Installation Instructions
Comprehensive installation guide for the White Rodgers 1F79 non-programmable heat pump thermostat, covering wiring, mounting, and operation for heating and air conditioning systems.
Předview White Rodgers Blue Single 1/1 Stage Thermostat Installation and Operating Instructions
This document provides installation and operating instructions for the White Rodgers Blue Single 1/1 Stage Thermostat, models 1F80-0471 and 1F86-0471. It covers applications, specifications, installation steps, thermostat operation, programming, and troubleshooting.
Předview White-Rodgers 1F95-0671 Universal Thermostat Installation and Operation Guide
Comprehensive installation and operating instructions for the White-Rodgers 1F95-0671 Universal Thermostat. Learn about its features, applications, specifications, wiring, programming, and troubleshooting.
Předview White Rodgers 1F95EZ-0671 Thermostat Installation and User Guide
Comprehensive installation, configuration, and user guide for the White Rodgers 1F95EZ-0671 thermostat. Learn how to install, wire, program, and troubleshoot your thermostat for optimal heating and cooling control.