1. Konec produktuview
The Fantech FB 6 In-line Filter Box is designed to enhance indoor air quality by providing additional filtration within your HVAC ductwork. It is typically installed after an HRV (Heat Recovery Ventilator) or an inline fan to filter incoming air. This unit includes a MERV 13 filter for efficient particle removal.
Obrázek 1: Vnější vzhled view of the Fantech FB 6 In-line Filter Box, showing the duct connection on the left and the access knob on the right.
2. Bezpečnostní informace
Please read all instructions carefully before installation and operation. Failure to follow these instructions may result in property damage, injury, or death.
- Ensure power to the HVAC system is disconnected before installation or maintenance.
- Během instalace a údržby používejte vhodné osobní ochranné prostředky (OOP).
- Consult a qualified HVAC professional for complex installations or if you are unsure about any steps.
- Nepoužívejte jednotku, pokud jsou některé součásti poškozené nebo chybí.
- Dispose of old filters according to local regulations.
3. Obsah balení
Před zahájením instalace ověřte, zda jsou přítomny všechny komponenty.
- Fantech FB 6 In-line Filter Box
- MERV 13 Filter (pre-installed or separate)
- Instalační příručka (tento návod)
4. Instalace a nastavení
4.1 Kontrolní seznam před instalací
- Confirm duct size compatibility (6-inch duct).
- Zajistěte dostatek prostoru pro instalaci a budoucí výměnu filtru.
- Gather necessary tools (e.g., duct cutters, sealant, screwdriver).
4.2 kroky instalace
- Vyberte umístění: Install the filter box in the ductwork after your HRV or inline fan, ensuring it is accessible for maintenance.
- Připravte potrubí: Cut a section of the existing 6-inch ductwork to accommodate the filter box. Ensure clean, straight cuts.
- Connect to Ductwork: Slide the filter box onto the prepared duct ends. Secure connections using appropriate duct clamps or screws and seal with HVAC-approved tape or mastic to prevent air leaks.
- Verify Filter Installation: Open the access panel (refer to Figure 2) and ensure the MERV 13 filter is correctly seated.
- Panel zabezpečeného přístupu: Close and secure the access panel using the provided knobs/screws.
Obrázek 2: Interiér view of the Fantech FB 6 In-line Filter Box with the access panel open, revealing the MERV 13 filter angled inside.
5. Provoz
The Fantech FB 6 In-line Filter Box operates passively as part of your ventilation system. Once installed, it continuously filters the air passing through it. No user interaction is required for its daily operation.
6. Údržba
6.1 Výměna filtru
Regular filter replacement is crucial for maintaining optimal air quality and system performance. The frequency of replacement depends on usage and environmental conditions, but it is generally recommended every 3-6 months.
- Odpojit napájení: Ensure the HVAC system connected to the filter box is powered off at the circuit breaker.
- Open Access Panel: Loosen the knobs/screws on the access panel and carefully open it.
- Odstraňte starý filtr: Gently slide out the old MERV 13 filter. Note its orientation for correct installation of the new filter.
- Vložit nový filtr: Slide a new MERV 13 filter into the filter box, ensuring it is properly seated and oriented.
- Zavřít přístupový panel: Close the access panel and tighten the knobs/screws securely.
- Obnovit napájení: Turn the power back on to the HVAC system.
7. Řešení problémů
| Problém | Možná příčina | Řešení |
|---|---|---|
| Condensation/Sweating on unit (in cold climates) | Insufficient insulation around the unit, especially when used for fresh air intake. | Apply additional insulation around the exterior of the filter box to prevent condensation. Ensure proper sealing. |
| Access panel screws spin freely / do not tighten | Internal riveted nut may have come loose or stripped. | Carefully inspect the internal nut. If loose, attempt to secure it. If stripped, consider using a different fastening method or contacting Fantech support. |
| Filter does not fit perfectly or seal properly | Screw heads or internal components obstructing filter path; incorrect filter size. | Ensure you are using the correct filter size (e.g., 20x20x1 if adapting). Carefully position the filter to avoid obstructions. |
8. Specifikace
| Funkce | Detail |
|---|---|
| Číslo modelu | FB 6 (CECOMINOD072653) |
| Výrobce | Fantech |
| Kompatibilita velikostí potrubí | 6 palců |
| Typ filtru zahrnutý | MERV 13 |
| Hmotnost položky | 10 libry (4.54 kg) |
| Rozměry balení | 26.9 x 15.1 x 13.1 palce (68.3 x 38.4 x 33.3 cm) |
| Materiál | 22-gauge galvanized steel with baked powder coat finish |
| UPC | 650737403041 |
9. Záruka a podpora
Informace o záruce a technickou podporu získáte od oficiálního zástupce společnosti Fantech. webnebo kontaktujte jejich zákaznický servis.
You can visit the official Fantech store on Amazon for more products and information: Obchod FANTECH.
