Marley QTS1504T Toe Kick Heater User Manual

1. Úvod

The Marley QTS1504T Toe Kick Heater is designed for discreet heating in areas with limited wall space, such as kitchens, bathrooms, and offices. Its compact design allows for installation in toe-kick areas under cabinets, stair risers, or bathroom vanities, providing efficient warmth without occupying valuable floor or wall space.

Obrázek 1: Přední strana view of the Marley QTS1504T Toe Kick Heater, showing the black grille and thermostat dial.

2. Bezpečnostní informace

Read all instructions before installing or using this heater. Failure to follow these instructions may result in electric shock, fire, or serious injury.

• Elektrická bezpečnost: This heater operates on 240 Volts. Installation must be performed by a qualified electrician in accordance with all local and national electrical codes. Ensure the power supply is disconnected before any installation or maintenance.
• Umístění: Do not install the heater directly below a permanent electrical outlet. Maintain adequate clearance from combustible materials such as furniture, curtains, and bedding.
• Ochrana proti přehřátí: The heater is equipped with a thermal cutout to prevent overheating. If the heater shuts off unexpectedly, allow it to cool down before attempting to reset or restart.
• Nezakrývejte: Never cover the heater or block its air intake/output grilles. This can cause overheating and fire.
• Vystavení vodě: Do not use this heater in wet or moist locations. Avoid contact with water.

3. Obsah balení

Upon unpacking, verify that all components are present and undamaged. The Marley QTS1504T Toe Kick Heater package typically includes:

• Marley QTS1504T Toe Kick Heater Unit
• Montážní materiál (šrouby, konzoly atd.)
• Uživatelská příručka / Instalační průvodce

If any parts are missing or damaged, do not attempt to install or operate the heater. Contact Marley customer support for assistance.

4. Nastavení a instalace

Proper installation is crucial for the safe and efficient operation of your toe kick heater. It is highly recommended that installation be performed by a qualified electrician.

4.1. Výběr místa

Choose a suitable location such as a toe-kick space under kitchen or utility room cabinets, a soffit area above cabinets, stair risers, or under a bathroom vanity. Ensure the chosen location allows for proper air circulation and is free from obstructions.

4.2. Elektrické požadavky

The Marley QTS1504T heater requires a 240 Volt, 15 Amp dedicated circuit. Ensure your electrical system can support these requirements. All wiring must comply with local and national electrical codes.

4.3. Montáž ohřívače

The heater features a 3-piece design for simplified installation. Create an opening in the chosen location that matches the heater's dimensions. Securely mount the heater unit using the provided hardware, ensuring it is level and stable. Connect the electrical wiring as per the detailed instructions in the included installation guide. Ensure all connections are tight and secure.

Image 2: Dimensions of the Marley QTS1504T Toe Kick Heater, measuring 8.88 inches deep, 15.38 inches wide, and 3.62 inches high.

5. Návod k obsluze

Once properly installed and connected to power, your Marley QTS1504T Toe Kick Heater is ready for operation.

5.1. Zapnutí/vypnutí

The heater is controlled by an integrated thermostat. To activate the heater, turn the thermostat dial to your desired heat setting. The unit will begin to produce heat. To turn off the heater, rotate the thermostat dial to its lowest setting or turn off the dedicated circuit breaker.

5.2. Regulace teploty

Adjust the temperature by rotating the thermostat dial located on the front grille. Turning the dial towards 'WARMER' will increase the heat output, while turning it towards 'COOLER' or 'OFF' will decrease or stop the heat output. The heater's cross-flow blower operates to distribute warmth quietly.

6. Údržba

Regular maintenance ensures optimal performance and longevity of your heater. Always disconnect power to the heater at the circuit breaker before performing any maintenance.

• Čištění: Periodically clean the air intake and output grilles to remove dust and debris. Use a soft brush or vacuum cleaner attachment. Do not use abrasive cleaners, solvents, or spray directly with liquids.
• Inspekce: Každoročně kontrolujte ohřívač, zda nevykazuje známky poškození, uvolněných spojů nebo neobvyklého opotřebení. Pokud zjistíte jakékoli problémy, obraťte se na kvalifikovaného technika s žádostí o opravu.

7. Řešení problémů

If you experience issues with your Marley QTS1504T Toe Kick Heater, refer to the following troubleshooting guide:

If troubleshooting steps do not resolve the issue, contact Marley customer support or a qualified electrician.

8. Specifikace

Key technical specifications for the Marley QTS1504T Toe Kick Heater:

• Značka: Marley
• Model: QTS1504T
• Tepelný výkon: 1500 wattů
• svtage: 240 voltů
• Amperage: 6.25 Amps
• Form Factor: Toe Kick
• Rozměry produktu (H x Š x V): 8.88 cm x 15.38 cm x 3.62 cm
• Vnitřní/venkovní použití: Krytý
• Speciální funkce: Noiseless (as per manufacturer specification)
• Barva: Černý
• Typ montáže: Recessed / Toe Kick Mount
• Doporučený typ pokoje: Koupelna, kuchyň, kancelář
• Pokrytí topení: Až 300 XNUMX čtverečních stop
• Typ paliva: Elektrický

9. Informace o záruce

This Marley product is covered by a manufacturer's warranty. For specific warranty terms, conditions, and duration, please refer to the warranty documentation included with your purchase. You may also visit the official Marley website or contact their customer support for detailed information regarding warranty claims and service.

10. Zákaznická podpora

For technical assistance, replacement parts, or service inquiries regarding your Marley QTS1504T Toe Kick Heater, please contact Marley customer support. Contact information, including phone numbers and email addresses, can typically be found on the manufacturer's webmístě nebo na obalu produktu.

Můžete také navštívit Obchod Marley na Amazonu pro další informace o produktu.