1. Úvod
This manual provides essential information for the proper installation, operation, and maintenance of your new metal detector search coil. Designed for compatibility with various metal detector models including Md6350, ACE350, TX 850, and FS2, this waterproof search coil enhances your treasure hunting experience by providing reliable detection capabilities.
Před použitím produktu si prosím pečlivě přečtěte tento návod k použití, abyste zajistili optimální výkon a dlouhou životnost.
2. Nastavení a instalace
Follow these steps to correctly attach the search coil to your compatible metal detector:
- Unpack the Coil: Carefully remove the search coil and its cable from the packaging. Inspect for any visible damage.
- Attach to Shaft: Secure the search coil to the lower shaft of your metal detector using the provided bolt and washers. Ensure it is snug but not overtightened, allowing for slight angle adjustment.
- Připojte kabel: Route the coil cable up the shaft, securing it with cable clips or electrical tape to prevent tangling. Plug the connector firmly into the corresponding port on your metal detector's control box. Ensure the pins align correctly before pushing to avoid damage.
Poznámka ke kompatibilitě:
- FS2 metal detector coils and TX850 coils are interchangeable.
- MD6350 metal detector coils are compatible with Ace350 metal detectors.
3. Návod k obsluze
Once the search coil is properly installed and connected, power on your metal detector and follow its specific operating instructions. Here are general guidelines for using the search coil:
- Ground Balance: Perform a ground balance procedure as instructed by your metal detector's manual to eliminate false signals from mineralized ground.
- Technika zametání: Hold the coil parallel to the ground, about 1-2 inches above the surface. Sweep the coil slowly from side to side in overlapping passes. Maintain a consistent height and speed for best results.
- Nastavení citlivosti: Adjust the sensitivity setting on your metal detector. Higher sensitivity can detect smaller or deeper targets but may also increase ground noise. Find a balance suitable for your search environment.
- Určení: When a target is detected, use a smaller, more precise sweeping motion over the target area to pinpoint its exact location.
- Vodotěsný design: This search coil is waterproof, allowing for use in shallow water, streams, and wet environments. Ensure the connector to the control box is dry and properly sealed if your detector's control box is not waterproof.
4. Údržba a péče
Proper maintenance will extend the life and performance of your search coil:
- Čištění: After each use, especially in wet or muddy conditions, clean the search coil with fresh water and a soft cloth. Avoid abrasive cleaners or solvents.
- Kontrola kabelů: Regularly inspect the coil cable for cuts, kinks, or damage. Ensure the connector pins are clean and free of corrosion.
- Skladování: Store the search coil in a dry, cool place away from direct sunlight and extreme temperatures. Avoid placing heavy objects on the coil or cable.
- Kryt cívky: If available, use a coil cover to protect the coil from scratches and impacts during use.
5. Řešení problémů
If you encounter issues with your search coil, refer to the following common problems and solutions:
| Problém | Možná příčina | Řešení |
|---|---|---|
| No signal or intermittent signal | Loose cable connection, damaged cable/coil, incorrect settings. | Ensure cable is securely connected. Inspect cable for damage. Check metal detector's sensitivity and ground balance settings. |
| Nadměrné množství falešných signálů | High sensitivity, poor ground balance, electromagnetic interference. | Reduce sensitivity. Re-perform ground balance. Move away from power lines or other electronic devices. |
| Coil not detecting targets | Too low sensitivity, coil too far from ground, target too deep/small. | Increase sensitivity. Keep coil closer to the ground. Ensure proper sweeping technique. |
6. Specifikace
| Funkce | Detail |
|---|---|
| Materiál | Pryž |
| Typ | Hand Tool Parts (Search Coil) |
| Vysoce znepokojená chemikálie | Žádný |
| Původ | pevninská Čína |
| Dostupné velikosti | 11-inch, 13-inch (bare disk/plate options) |
| Kompatibilita | Md6350, ACE350, TX 850, FS2 metal detectors |
| Vodotěsný | Ano |
7. Uživatelské tipy
- Always check your metal detector's battery level before a search session to avoid interruptions.
- When searching in areas with high mineralization, consider reducing your detector's sensitivity slightly to minimize false signals and improve target identification.
- Practice with known targets (coins, jewelry) in a clear area to familiarize yourself with the coil's response and your detector's audio tones.
- For deep targets, a slower sweep speed can sometimes improve detection.
8. Záruka a podpora
For any questions, technical support, or warranty inquiries regarding your search coil, please contact the seller or manufacturer directly. Keep your purchase records for reference.
