Uživatelská příručka motoru hlavního kartáče AMIBOT Animal Premium Connect X782

Zavedení

This manual provides essential information for the installation, operation, maintenance, and troubleshooting of your AMIBOT Animal Premium Connect X782 main brush motor. This motor is a replacement part designed for use with AMIBOT Animal Premium Connect X782 and Amibot Animal H2o robotic vacuum cleaners. Please read this manual carefully before attempting any installation or maintenance.

Bezpečnostní informace

Always disconnect the vacuum cleaner from its power source before attempting any installation, removal, or maintenance of the motor.
Handle the motor with care to avoid damage to the wires or circuit board.
Pokud si nejste jisti některým krokem, poraďte se s kvalifikovaným technikem.
Udržujte malé části mimo dosah dětí.

Nastavení a instalace

The main brush motor is an internal component. Installation typically involves disassembling part of the vacuum cleaner to access the brush module. The following steps are general guidelines; refer to your specific vacuum cleaner's service manual for detailed disassembly instructions.

Připravte si vysavač: Ensure the vacuum cleaner is turned off and unplugged from its charging base. Remove the dustbin and main brush cover.
Access the Brush Module: Depending on your vacuum model, you may need to remove screws or clips to access the main brush motor compartment.
Odpojení starého motoru: Carefully disconnect the wiring harness from the old motor. Note the orientation of the connector.
Demontáž starého motoru: Unfasten any screws or clips holding the old motor in place and gently remove it.
Instalace nového motoru: Position the new AMIBOT main brush motor into the compartment. Ensure it fits securely.
Připojení kabeláže: Connect the wiring harness to the new motor. The connector is designed to fit in only one orientation.
Zabezpečený motor: Fasten any screws or clips to secure the new motor.
Reassemble Vacuum Cleaner: Reassemble the vacuum cleaner in reverse order of disassembly. Ensure all parts are correctly seated and screws are tightened.

AMIBOT Main Brush Motor side view — Obrázek 1: Strana view of the AMIBOT main brush motor with wiring and connector. This view shows the general shape and connection points.

AMIBOT Main Brush Motor angled view s převodem — Obrázek 2: Úhlové view of the motor, highlighting the drive gear and wiring connector. Pay attention to the gear for proper alignment during installation.

Hand holding AMIBOT Main Brush Motor showing circuit board — Figure 3: Close-up of the motor's circuit board and wiring connection. This illustrates the precise connection point for the vacuum's internal wiring.

AMIBOT Main Brush Motor rear view s kolíky — Obrázek 4: Zadní view of the motor, showing the pins and overall construction. This helps in identifying the correct replacement part.

Návod k obsluze

Once the main brush motor is correctly installed, the vacuum cleaner should operate as intended. The motor powers the main rotating brush, which is crucial for effective cleaning. No specific operating instructions are required for the motor itself, as its function is integrated into the vacuum cleaner's overall operation.

Ensure the main brush is free from obstructions (hair, debris) before and after each cleaning cycle.
Regularly check the main brush for wear and tear.
If the main brush stops rotating or makes unusual noises, refer to the troubleshooting section.

Údržba

Proper maintenance ensures the longevity and optimal performance of your main brush motor and vacuum cleaner.

Čištění kartáčů: Regularly remove the main brush from the vacuum cleaner and clean it thoroughly. Remove any tangled hair, threads, or debris that might impede its rotation.
Motor Area Inspection: Periodically inspect the motor compartment for dust or debris accumulation. Use a soft brush or compressed air to clean if necessary.
Kontrola zapojení: Ensure the motor's wiring and connector remain securely attached and free from damage.
Vyhněte se přetížení: Do not operate the vacuum cleaner on excessively thick carpets or areas with large debris that could strain the motor.

Odstraňování problémů

If you encounter issues after installing the new main brush motor, consider the following:

Problém	Možná příčina	Řešení
Main brush not rotating	Brush tangled with hair/debris Motor wiring loose or disconnected Motor faulty (unlikely if new) Vacuum cleaner software error	Clean the main brush thoroughly. Check motor connections; re-seat if loose. Restart the vacuum cleaner. If problem persists, consult vacuum cleaner's manual or support.
Unusual noise from brush area	Debris caught in brush or motor housing Brush not installed correctly Problém s ložiskem motoru	Remove and clean the main brush and brush compartment. Ensure the main brush is correctly seated. If noise persists, the motor might be defective; contact support.
Vacuum cleaner not turning on after motor replacement	Nesprávná zpětná montáž Main power connection issue Baterie není nabitá	Double-check all internal connections and reassembly steps. Ensure the vacuum is properly charged. Verify the main power switch is on.

Specifikace

Atribut	Detail
Typ produktu	Vacuum Cleaner Parts (Motors)
Číslo modelu	AMIBOT Animal Premium Connect X782
Kompatibilita	AMIBOT Animal Premium Connect X782, Amibot Animal H2o
Původ	CN (Čína)
Chemikálie	Žádný
Hmotnost balení	0.15 kg
Rozměry balení (D x Š x V)	15 cm x 10 cm x 10 cm

Tipy pro uživatele

Before replacing the motor, take photos of the existing connections to aid in reassembly.
Use appropriate tools to avoid stripping screws or damaging plastic components during disassembly and reassembly.
After installation, run a short test cycle to ensure the main brush rotates smoothly and quietly.

Záruka a podpora

This product is a replacement part. For warranty information regarding the motor itself, please refer to the seller's policy or contact the seller directly. For issues related to the overall vacuum cleaner's operation after motor replacement, consult the original vacuum cleaner's user manual or contact AMIBOT customer support.

	AMIBOT Flex H2O Connect : Aspirateur Robot Laveur Intelligent pour Tous Sols Découvrez l'AMIBOT Flex H2O Connect, aspirační robot laveur polyvalent. Personalizujte síť, kontrolu na dálku pomocí aplikace a zisk z technologie H2O nalévejte bezvadné soli na různých typech povrchů.
	Uživatelská příručka robotického vysavače a mopu AMIBOT pro zvířata Komplexní uživatelská příručka k robotickému vysavači a mopu AMIBOT Animal Robot Vacuum and Mop, která zahrnuje produkt přes...view, provozní režimy (vysávání, mop, automatický, bodové, náhodné, MAX), nabíjení, programování, údržba, řešení problémů, technické specifikace, bezpečnostní opatření a pokyny pro recyklaci. Optimalizujte svůj úklid s tímto všestranným robotem.
	Stručný průvodce aplikací Amibot Animal MOTION Naučte se, jak nastavit a používat robotický vysavač Amibot Animal MOTION, s tímto rychlým návodem k mobilní aplikaci. Stáhněte si aplikaci, připojte robota a spravujte úklid.
	Stručný návod k obsluze Amibot Animal Origin – Nastavení a provoz Stručný návod k rychlému použití robotického vysavače Amibot Animal Origin s podrobným popisem nastavení, nabíjení a prvního uvedení do provozu.
	Uživatelská příručka k robotickému vysavači AMIBOT Spirit PREMIUM a PREMIUM STATION \| Průvodce nastavením a obsluhou Komplexní uživatelská příručka k robotickému vysavači AMIBOT Spirit PREMIUM a PREMIUM STATION. Naučte se, jak nastavit, obsluhovat, udržovat a řešit problémy s vaším chytrým úklidovým zařízením. Zahrnuje podrobnosti o integraci aplikací.
	Stručný návod k obsluze Amibot Animal Motion Stručný návod k nastavení a nabíjení robotického vysavače Amibot Animal Motion, včetně pokynů k umístění nabíjecí stanice a počátečních postupů dokování.

AMIBOT AMIBOT Animal Premium Connect X782