EAZYRC FMS 1/24 FCX24M RC Crawler (Defender90)

1. Přesview

The EAZYRC FMS 1/24 FCX24M RC Crawler, Defender90 model, is a highly detailed, ready-to-run (RTR) remote-controlled vehicle. This model features an officially authorized rugged appearance, faithfully replicating its Eastnor Yellow paint, intricate interior, and accessories like the roof rack, paying homage to the thrilling spirit of the Camel Trophy. Designed for off-road enthusiasts, it offers a realistic driving experience with advanced features.

Figure 1: EAZYRC FMS 1/24 Land Rover Series RC Crawlers, Camel Trophy Edition, showcasing various models including the Defender90.

2. Co je v krabici

Your EAZYRC FMS 1/24 FCX24M RC Crawler package includes the following components:

• 1x EAZYRC FMS 1/24 FCX24M RC Crawler (Defender90)
• 1x 2.4Ghz Remote Control
• 1x Lithium Polymer Battery (7.4V, included)
• 1x USB Battery Charger
• 1x Small Screwdriver and spare screws
• Various accessory parts (e.g., R3A Receiver V3, Steering Servo, Oil Shock Absorbers Assembly, 050 Motor Set, Front Axle Assembly, Rear Axle Assembly, Ball Bearing Set)

Obrázek 2: Rozložené view of the FCX24M Chassis components, including the R3A Receiver V3, Steering Servo, Oil Shock Absorbers Assembly, 050 Motor Set, Front Axle Assembly, Rear Axle Assembly, Ball Bearing Set, and LiPo Battery.

3. Nastavení

3.1. Nabíjení baterie vozidla

1. Locate the 7.4V Lithium Polymer battery and the USB charger.
2. Připojte baterii k USB nabíječce.
3. Plug the USB charger into a compatible USB power source (e.g., computer USB port, USB wall adapter). The charging time is approximately 4-5 hours. The LED indicator on the charger will show charging status (usually red for charging, green for full).
4. Po úplném nabití odpojte baterii od nabíječky.

3.2. Vložení baterií do dálkového ovladače

1. Vyhledejte přihrádku na baterie na spodní straně dálkového ovladače.
2. Pomocí malého šroubováku otevřete kryt přihrádky na baterie.
3. Insert 2x 1.5V AA alkaline non-rechargeable batteries, ensuring correct polarity.
4. Nasaďte kryt prostoru pro baterie a zajistěte jej šroubem.

3.3. Installing the Vehicle Battery

1. Open the rear bed of the RC crawler to access the battery compartment.
2. Connect the charged 7.4V LiPo battery to the vehicle's power interface, ensuring a secure connection.
3. Carefully place the battery into the compartment and close the rear bed.

3.4. Binding the Remote Control and Vehicle

The vehicle and remote control are typically pre-bound from the factory. If re-binding is necessary:

1. Ensure both the vehicle and remote control are turned OFF.
2. Turn ON the remote control. The power LED will blink.
3. Turn ON the vehicle. The power LED on the remote control should become solid, indicating a successful bind.
4. If the binding fails, repeat the steps or consult the troubleshooting section.

Figure 3: The 2.4Ghz Remote Control for the FCX24M RC Crawler.

4. Provoz

4.1. Základní ovládací prvky

• Spoušť plynu: Pull the trigger to move forward. Push the trigger away from you to brake, then push again for reverse.
• Volant: Otáčením volantu doleva nebo doprava ovládáte směr vozidla.
• Obložení řízení: Use the steering trim dial on the remote control to adjust the steering so the vehicle drives straight when the steering wheel is centered.

4.2. Two-Speed Transmission

The FCX24M features a two-speed transmission for versatile driving. Refer to your remote control's specific buttons or switches for shifting between high and low gears. Low gear provides more torque for crawling over obstacles, while high gear offers faster speeds for open terrain.

4.3. Systém osvětlení

The vehicle is equipped with brightenable headlights. The lighting can typically be controlled via a switch or button on the remote control. Consult your remote control's manual for specific lighting controls.

4.4. Tipy pro řízení

• Always operate your RC crawler in a safe and open area, away from people, pets, and obstacles.
• Avoid driving in deep water or extreme mud unless the vehicle is specifically rated for such conditions, as this can damage electronics.
• Practice driving in various terrains to get accustomed to the vehicle's handling characteristics.

5. Údržba

5.1. Čištění

• After each use, especially in dirty or dusty conditions, clean the vehicle to prevent debris from affecting performance.
• Use a soft brush or compressed air to remove loose dirt. A damp cloth can be used for stubborn grime, but avoid excessive moisture on electronic components.

5.2. Péče o baterie

• Always fully charge the LiPo battery before use.
• Do not overcharge or completely discharge the battery, as this can reduce its lifespan.
• Baterie skladujte na chladném a suchém místě mimo dosah přímého slunečního záření a extrémních teplot.
• Pokud vozidlo a dálkový ovladač delší dobu nepoužíváte, vyjměte baterie z něj.

5.3. Generální inspekce

• Regularly inspect all screws, linkages, and moving parts for looseness or damage. Tighten any loose screws.
• Check the tires for wear and tear. Replace if necessary to maintain optimal traction.
• Ensure all wires and connectors are secure and free from damage.

6. Řešení problémů

7. Specifikace

• Model: Defender 90
• Rozměry produktu: 9.5 x 4.2 x 5 palce
• Hmotnost položky: 2.29 libry
• Baterie: 1 Lithium Polymer battery (7.4V, included)
• Doporučený věk: 16 let a více
• Měřítko: 1/24
• Řídit: 4X4

8. Záruka a podpora

For warranty information, please refer to the documentation included with your purchase or contact the retailer. For technical support, parts, or service inquiries, please contact EAZYRC customer service through their official webna webu nebo u prodejce, kde byl produkt zakoupen.