1. Konec produktuview
The Thermalright Phantom Spirit 120 EVO is a high-performance CPU air cooler designed to efficiently dissipate heat from your processor. It features a dual-tower heatsink design, seven advanced heat pipes, and two TL-K12 PWM fans for optimal cooling and quiet operation. This cooler is compatible with a wide range of Intel and AMD sockets.

Obrázek 1.1: Konecview of the Thermalright Phantom Spirit 120 EVO CPU Cooler, showcasing its dual-tower design and fans.
Klíčové vlastnosti:
- Dual-Tower Heatsink: Provides a large surface area for heat dissipation.
- 7x6mm AGHP Heat Pipes: Advanced Gravity Heat Pipe technology ensures efficient heat transfer regardless of orientation.
- Dual TL-K12 PWM Fans: 120mm fans with a maximum speed of 2150 RPM and low noise levels (≤27dB(A)).
- Anodic Black Matte Finish: Enhances aesthetics and corrosion resistance.
- Široká kompatibilita: Supports Intel LGA1700/115x/1200/2011/2066 and AMD AM4/AM5 sockets.
2. Obsah balení
Please verify that all components are present before proceeding with the installation.
- Thermalright Phantom Spirit 120 EVO CPU Cooler (Heatsink with pre-installed fans)
- Intel Mounting Brackets and Backplate
- Montážní držáky AMD
- Montážní šrouby a podložky
- Termální pasta
- Fan Clips (if not pre-installed)
- Uživatelská příručka
3. Instalační příručka
Before starting, ensure your system is powered off and unplugged. Refer to your motherboard manual for CPU and RAM installation if not already done.
3.1 Připravte základní desku
- Remove any existing CPU cooler and clean off old thermal paste from the CPU IHS (Integrated Heat Spreader) using isopropyl alcohol.
- Identify your CPU socket type (Intel LGA or AMD AM).
3.2 Nainstalujte montážní hardware
For Intel Sockets (LGA1700/115x/1200/2011/2066):
- Place the Intel backplate behind the motherboard, aligning the holes with the CPU socket mounting holes.
- Insert the appropriate standoffs through the motherboard from the front, screwing them into the backplate.
- Attach the Intel mounting brackets to the standoffs using the provided screws.
For AMD Sockets (AM4/AM5):
- Remove the plastic retention clips from the stock AMD backplate (keep the backplate).
- Install the AMD standoffs onto the stock backplate.
- Attach the AMD mounting brackets to the standoffs using the provided screws.

Image 3.1: Diagram showing compatible motherboard sockets for Intel (LGA115X/1200/1700/2011/2066) and AMD (AM4/AM5).
3.3 Naneste teplovzdornou pastu
Apply a small, pea-sized amount of thermal paste to the center of the CPU IHS. Do not spread it; the pressure from the cooler will distribute it evenly.
3.4 Mount the Heatsink
- Carefully place the heatsink onto the CPU, aligning the mounting holes on the cooler base with the mounting brackets.
- Secure the heatsink by tightening the spring-loaded screws in a diagonal pattern until snug. Do not overtighten.
3.5 Install Fans and Connect Cables
- Attach the two TL-K12 fans to the heatsink using the provided fan clips. Ensure the airflow direction is correct (typically blowing towards the rear of the case).
- Connect the 4-pin PWM fan cables to the CPU_FAN and CPU_OPT (or CHA_FAN) headers on your motherboard. The Y-splitter cable can be used if only one CPU fan header is available.

Image 3.2: Illustration of the dual-tower heatsink and dual fans, demonstrating how they contribute to efficient CPU cooling.
4. Návod k obsluze
Once installed, the Thermalright Phantom Spirit 120 EVO operates automatically, controlled by your motherboard's PWM fan headers.
4.1 Řízení otáček ventilátoru (PWM)
The TL-K12 fans utilize Pulse Width Modulation (PWM) technology, allowing your motherboard to dynamically adjust fan speeds based on CPU temperature. This ensures optimal cooling performance while minimizing noise during lighter loads.
- You can configure fan curves in your motherboard's BIOS/UEFI settings or through compatible software provided by your motherboard manufacturer.
- The fans operate at a maximum speed of 2150 RPM ±10% and produce a maximum noise level of ≤27dB(A).

Obrázek 4.1: Detail view of the TL-K12 120mm high-performance fan, highlighting its design and RGB lighting.
4.2 Initial System Check
After installation, power on your system and enter the BIOS/UEFI to verify that the CPU temperature is within normal operating limits and that the fans are spinning correctly.
5. Údržba
Pravidelná údržba pomáhá zajistit dlouhou životnost a optimální výkon chladiče procesoru.
5.1 Cleaning the Heatsink and Fans
Dust accumulation can impede cooling performance. It is recommended to clean the cooler every 6-12 months, or more frequently in dusty environments.
- Vypněte počítač a odpojte jej ze zásuvky.
- Carefully remove the fans from the heatsink by detaching the fan clips.
- Use compressed air to blow dust out of the heatsink fins. Hold the can upright and use short bursts.
- Clean the fan blades with a soft cloth or compressed air. Hold the fan blades to prevent them from spinning rapidly during cleaning, which can damage the bearings.
- Reattach the fans to the heatsink.
5.2 Thermal Paste Reapplication
While not frequently required, reapplying thermal paste every few years can help maintain optimal thermal conductivity. If you notice significantly higher CPU temperatures, consider reapplying thermal paste.
6. Řešení problémů
If you encounter issues with your CPU cooler, refer to the following common problems and solutions.
| Problém | Možná příčina | Řešení |
|---|---|---|
| Vysoké teploty procesoru |
|
|
| Ventilátory se netočí |
|
|
| Nadměrný hluk ventilátoru |
|
|
7. Specifikace
Detailed technical specifications for the Thermalright Phantom Spirit 120 EVO CPU Cooler.

Image 7.1: Dimensional drawing of the Phantom Spirit 120 EVO, showing its height (157mm), width (135mm), and length (125mm).
| Funkce | Specifikace |
|---|---|
| Číslo modelu | PS120 EVO (TL-PS120 EVO) |
| Rozměry (D x Š x V) | 12.5 cm x 13.5 cm x 15.7 cm |
| Způsob chlazení | Chlazení vzduchem |
| Tepelné trubky | 7 x 6mm AGHP Heat Pipes (Nickel-plated copper) |
| Základní materiál | Precisely Micro-Engraved Reflow Soldered Copper Base |
| Model ventilátoru | TL-K12 PWM Fan |
| Rozměry ventilátoru | 120 mm x 120 mm x 25 mm |
| Rychlost ventilátoru | 2150 RPM ±10% (Max) |
| Proudění vzduchu | 69 CFM (Max) |
| Úroveň hluku | ≤27 dB(A) |
| Napájecí konektor | 4-Pin PWM |
| svtage | 12V |
| Kompatibilní zásuvky | Intel: LGA1700 / 1150 / 1151 / 1155 / 1156 / 1200 / 2011 / 2066 AMD: AM4 / AM5 |
| Materiál | Copper (Heat Pipes, Base), Aluminum (Fins), PBT + PC (Fans) |
8. Informace o záruce
Thermalright products are manufactured to the highest quality standards. This product is covered by a limited warranty against defects in materials and workmanship from the date of purchase.
Please retain your proof of purchase for warranty claims. The warranty does not cover damage resulting from improper installation, accident, abuse, misuse, natural disaster, or unauthorized modification.
For specific warranty duration and terms, please refer to the official Thermalright webstránky nebo se obraťte na svého místního distributora.
9. Podpora
If you require technical assistance or have questions regarding the Thermalright Phantom Spirit 120 EVO CPU Cooler, please contact Thermalright customer support.
- Webmísto: Visit the official Thermalright webweb s nejčastějšími dotazy, aktualizovanými manuály a zdroji podpory.
- E-mail: Refer to the Thermalright webweb s e-mailovými adresami zákaznického servisu.
- Místní distributor: Contact your point of purchase or local Thermalright distributor for regional support.