Zavedení
This manual provides essential information for the proper setup, operation, and maintenance of your HAIBOXING 2.4GHz Radio Transmitter, model 12670-2.4G. This transmitter is designed for use with HAIBOXING RC car models 16889, 903, 905, and 2995. Please read this manual thoroughly before use to ensure optimal performance and safety.
Co je v krabici
- One (1) Radio Transmitter (Model 12670-2.4G)
Note: Additional components such as receivers, ESCs, motors, and batteries are typically sold separately or included with the RC vehicle.
Konec produktuview
The HAIBOXING 2.4GHz Radio Transmitter provides reliable control for your compatible RC vehicles. It features a pistol-grip design with various controls for precise operation.
Popis obrázku: Detailní view of the HAIBOXING 2.4GHz Radio Transmitter, highlighting its key components such as the Steering Trim, Power ON/OFF switch, Steering Direction Reverse Switch, Throttle Limiter, Control Wheel, Trigger, and AUX. Button. The image also indicates "RTR Ready to Run", "2.4GHz Proportional Control", and "280 feet Control Range".
Setup and Binding
To establish communication between your transmitter and receiver, follow these binding instructions. Ensure all components are powered off before starting.
Postup vázání
- Connect the receiver to a power source (e.g., ESC with BEC or a separate receiver battery).
- Power on the receiver. The LED on the receiver should flash, indicating it is in binding mode.
- Zapněte vysílač.
- Locate the "BIND" button on the receiver. Press and hold the "BIND" button for approximately 3 seconds.
- Observe the LED on the receiver. Once the LED changes from fast flashing to a solid light, the binding process is complete.
- Verify binding by connecting a servo to Channel 1 on the receiver and turning the steering wheel on the transmitter. The servo should respond.
Popis videa: This video demonstrates the binding method for a DUMBORC X4 Radio Transmitter with an X6F Receiver. It shows how to power on the receiver, then the transmitter, and then press the bind button on the receiver until the LED light becomes solid, indicating successful binding. A servo is then connected to verify the binding.
Popis videa: This video provides a connection schematic diagram for a 4-channel RC Transmitter with a Receiver, showing how to connect the various components like the ESC, motor, servo, and battery to the receiver and transmitter for proper operation and binding.
Obsluha vysílače
The 2.4GHz Radio Transmitter features several adjustable controls to fine-tune your RC vehicle's performance.
- Steering Trim (ST/TRIM): Adjusts the neutral position of the steering. Use this to make the vehicle drive straight when the steering wheel is centered.
- Throttle Trim (TH/TRIM): Adjusts the neutral position of the throttle. Use this to ensure the vehicle remains stationary when the throttle trigger is released.
- Steering Dual Rate (ST D/R): Nastavuje maximální úhel řízení.
- Throttle Dual Rate (TH D/R): Adjusts the maximum throttle output.
- Steering Direction Reverse Switch (ST DIR): Reverses the steering direction.
- Throttle Direction Reverse Switch (TH DIR): Reverses the throttle direction.
- Spoušť: Controls forward/reverse movement and speed.
- Ovládací kolečko: Ovládá řízení vlevo/vpravo.
- Zapnutí/vypnutí: Turns the transmitter on or off.
- LED indikátor: Shows the power and binding status.
Odstraňování problémů
If you encounter issues with your HAIBOXING 2.4GHz Radio Transmitter, refer to the following common troubleshooting steps:
Throttle or Steering Not Responding
- Zkontrolujte vazbu: Ensure the transmitter and receiver are properly bound. Refer to the "Setup and Binding" section.
- Adjust Throttle Trim (TH/TRIM): If the steering works but the throttle does not, adjust the TH/TRIM knob to the neutral (center) position. The ESC may not recognize the throttle input if the trim is off-center.
- Adjust Throttle Dual Rate (TH D/R): If the motor does not respond or moves slowly, adjust the TH D/R to its maximum value.
- Adjust Steering Dual Rate (ST D/R): If there is no steering response, adjust the ST D/R to its maximum value.
- Kalibrace ESC: If the issue persists, check the Electronic Speed Controller (ESC). Calibrate it and ensure it is in the correct two-way working mode.
Popis videa: This video addresses common issues where the throttle or steering may not work on an RC vehicle. It demonstrates how to adjust the throttle sub-trim and throttle dual rate (TH D/R) on the transmitter to resolve these problems, ensuring the ESC recognizes the throttle input and the motor responds correctly.
Specifikace
| Funkce | Detail |
|---|---|
| Číslo náhradního dílu | 12670-2.4G |
| Název položky | Radiový vysílač |
| Kompatibilita | HAIBOXING RC Car Models: 16889, 903, 905, 2995 |
| Rozměry produktu | 10 x 5 x 7 palce |
| Hmotnost položky | 6.7 unce |
| Výrobcem doporučený věk | 14 let a více |
Údržba
To ensure the longevity and optimal performance of your HAIBOXING 2.4GHz Radio Transmitter, follow these general maintenance guidelines:
- Keep the transmitter clean and free from dust, dirt, and moisture. Use a soft, dry cloth for cleaning.
- Nevystavujte vysílač extrémním teplotám nebo přímému slunečnímu záření po delší dobu.
- Pokud vysílač nebudete delší dobu používat, vyjměte z něj baterie, abyste zabránili jejich vytečení.
- Vysílač uložte na bezpečném místě, abyste zabránili jeho fyzickému poškození.
Záruka a podpora
Specific warranty information for the HAIBOXING 2.4GHz Radio Transmitter (Model 12670-2.4G) is not provided in this document. For detailed warranty terms, technical support, or replacement parts, please refer to the official HAIBOXING webwebu nebo se obraťte přímo na jejich zákaznický servis. Uschovejte si účtenku jako doklad o koupi.
You can visit the official HAIBOXING store for more products and support: HAIBOXING Store