LEDONE Full Cut Off 60W LED Wall Pack Light

1. Úvod

This manual provides essential information for the safe installation, operation, and maintenance of your LEDONE Full Cut Off 60W LED Wall Pack Light. Please read these instructions thoroughly before installation and retain them for future reference. This fixture is designed for outdoor use in commercial and industrial settings, featuring a full cut-off design to minimize light pollution and a built-in photocell for dusk-to-dawn operation.

Obrázek 1.1: Přední strana view of the LEDONE 60W Full Cut Off LED Wall Pack Light. This image displays the fixture's dark bronze housing and the array of LED lights behind a clear, tempered glass lens.

2. Bezpečnostní informace

• VAROVÁNÍ: Nebezpečí úrazu elektrickým proudem. Před instalací nebo servisem odpojte napájení pojistkou nebo jističem.
• Instalaci musí provést kvalifikovaný elektrikář v souladu se všemi národními a místními elektrotechnickými předpisy.
• Zajistěte přívod objtage is compatible with the fixture (120-277V AC).
• Do not handle live wires.
• Během instalace používejte ochranné brýle a rukavice.
• Ujistěte se, že je svítidlo bezpečně upevněno, aby nedošlo k jeho pádu.
• Nepokoušejte se svítidlo upravovat. Jakékoli úpravy ruší platnost záruky.

3. Obsah balení

Před instalací ověřte, zda jsou všechny součásti přítomny a nepoškozené.

• 1 x LEDONE Full Cut Off 60W LED Wall Pack Light Fixture
• Mounting Hardware (screws, anchors, gaskets)
• Návod k použití (tento dokument)

4. Specifikace

Image 4.1: Dimensional drawing of the LEDONE 60W Wall Pack Light, showing measurements of 11.5 inches (293mm) in length, 10.8 inches (275mm) in width, and 3.9 inches (100mm) in height.

5. Nastavení a instalace

Než začnete:

• Vypněte napájení jističem nebo pojistkovou skříňkou.
• Ensure the mounting surface is structurally sound and can support the fixture's weight.
• Have necessary tools ready: screwdriver, wire strippers, drill, sealant (if required for weatherproofing).

Montážní pokyny:

1. Opatrně vyjměte svítidlo z obalu.
2. Detach the mounting plate from the back of the fixture.
3. Position the mounting plate on the desired wall location. Mark the drilling points for the mounting screws.
4. Vyvrtejte pilotní otvory a v případě potřeby vložte vhodné kotvy.
5. Secure the mounting plate to the wall using the provided screws. Ensure it is level and tight.

Obrázek 5.1: Zadní strana view of the LEDONE 60W Wall Pack Light, illustrating the integrated mounting bracket and conduit entry point for electrical wiring.

Pokyny pro zapojení:

6. Feed the electrical supply wires through the conduit entry point on the mounting plate.
7. Connect the fixture's wires to the supply wires using appropriate wire connectors:
   • Black wire (Fixture) to Live/Hot wire (Supply)
   • White wire (Fixture) to Neutral wire (Supply)
   • Green/Ground wire (Fixture) to Ground wire (Supply)
8. Ujistěte se, že všechny spoje jsou bezpečné a řádně izolované.
9. Carefully tuck all wires into the junction box or mounting plate cavity.
10. Attach the fixture body to the mounting plate, ensuring a tight seal to maintain IP65 rating. Secure with screws.
11. Apply silicone sealant around the edges of the fixture and conduit entry points if necessary to prevent water ingress.
12. Obnovte napájení na jističi.

6. Návod k obsluze

This LED wall pack light is equipped with a built-in photocell for automatic dusk-to-dawn operation. No manual intervention is required after installation.

• Funkce od soumraku do úsvitu: The integrated photocell sensor detects ambient light levels. The fixture will automatically turn ON when natural light falls below a certain threshold (dusk) and turn OFF when sufficient natural light is detected (dawn).
• Rotatable Fixture: The fixture can be rotated by 15 degrees to adjust the light direction. This adjustment should be made during installation or maintenance when power is OFF. Loosen the appropriate screws, adjust the angle, and re-tighten securely.

Image 6.1: LEDONE 60W Wall Pack Lights installed on the exterior of a commercial building at night, demonstrating their effective illumination for large outdoor areas.

7. Údržba

The LEDONE Wall Pack Light is designed for minimal maintenance. Regular inspection and cleaning will ensure optimal performance and longevity.

• Čištění: Periodically clean the exterior of the fixture, especially the lens and photocell, with a soft, damp cloth to remove dirt, dust, and debris. Ensure power is OFF before cleaning. Do not use abrasive cleaners or solvents.
• Inspekce: Každoročně kontrolujte svítidlo, zda nevykazuje známky poškození, uvolněného zapojení nebo koroze. Ujistěte se, že všechny montážní šrouby jsou pevně utažené.
• Fotobuňka: Keep the photocell sensor clear of obstructions (e.g., leaves, dirt, paint) to ensure proper dusk-to-dawn operation.

8. Řešení problémů

9. Informace o záruce

The LEDONE Full Cut Off 60W LED Wall Pack Light is covered by a Omezená záruka. This product is designed for a long operational life of approximately 50,000 hours. For specific warranty terms and conditions, please refer to the warranty documentation provided at the time of purchase or contact LEDONE customer service.

10. Podpora

LEDONE is committed to providing quality lighting solutions and customer service. If you have any questions, require technical assistance, or need to report an issue with your product, please contact LEDONE customer support. Our team is based in California and ready to assist you.

For further assistance, please visit the official LEDONE webkontaktní údaje naleznete na webových stránkách nebo v dokumentaci k nákupu.