Streamlight Stinger LED HL 120/DC PB

Streamlight Stinger LED HL 120/DC PB Flashlight

Návod k použití

1. Úvod

This manual provides detailed instructions for the safe and effective use of your Streamlight Stinger LED HL 120/DC PB rechargeable flashlight. Please read all instructions carefully before operating the device.

Bezpečnostní informace

  • Do not look directly into the LED light. The intense beam can cause temporary vision impairment.
  • Uchovávejte mimo dosah dětí.
  • Use only Streamlight approved batteries and charging equipment.
  • Do not attempt to disassemble the flashlight head or battery pack.
  • Nevystavujte svítilnu extrémním teplotám nebo korozivním kapalinám.
Streamlight Stinger LED HL 120/DC PB Flashlight

Figure 1: Streamlight Stinger LED HL 120/DC PB Flashlight. This image shows the blue tactical flashlight with its distinct head and body design.

2. Nastavení

2.1 Počáteční nabití baterie

Your Streamlight Stinger LED HL 120/DC PB flashlight comes with a rechargeable NiMH battery. Before first use, fully charge the battery.

  1. Connect the charging cord to the charger base and plug it into a suitable power source (120V AC or 12V DC).
  2. Insert the flashlight into the charger base. Ensure the charging contacts on the flashlight align with those in the charger.
  3. The charging indicator light on the charger will illuminate, typically red, to indicate charging is in progress.
  4. Allow approximately 10-12 hours for a full charge if the battery is completely depleted. The indicator light may change color (e.g., green) or turn off when charging is complete, depending on the charger model.

2.2 Battery Installation (if required)

The battery is typically pre-installed. If you need to replace or install the battery:

  1. Odšroubujte zadní krytku svítilny otáčením proti směru hodinových ručiček.
  2. Insert the NiMH battery with the positive (+) terminal facing towards the head of the flashlight.
  3. Zašroubujte zadní víčko zpět ve směru hodinových ručiček, dokud nebude bezpečně utaženo.

3. Návod k obsluze

The Stinger LED HL 120/DC PB features multiple lighting modes controlled by a single push-button switch.

3.1 Zapnutí/vypnutí a výběr režimu

  • Zapnutí: Press and release the push-button switch. The flashlight will activate in the last used mode (High, Medium, or Low).
  • Pro přepínání režimů: With the flashlight on, press and release the switch repeatedly within 1.5 seconds to cycle through High, Medium, and Low brightness settings.
  • To activate Strobe: From any mode (on or off), press and hold the switch for approximately 2 seconds. Release to turn off strobe.
  • Vypnutí: Press and release the switch when the flashlight has been in a single mode for more than 1.5 seconds.

3.2 Recharging the Flashlight

When the light output diminishes, it indicates the battery needs recharging. Follow the steps in Section 2.1 to recharge the flashlight.

4. Údržba

4.1 Čištění

  • Otřete tělo baterky čističemamp tkanina. Nepoužívejte abrazivní čisticí prostředky nebo rozpouštědla.
  • Clean the charging contacts periodically with a clean, dry cloth to ensure proper connection.

4.2 Péče o baterie a jejich výměna

  • For optimal battery life, avoid fully discharging the battery before recharging.
  • If the flashlight will not be used for an extended period, store it with a partial charge and recharge every few months.
  • Replace the NiMH battery when its run time significantly decreases. Use only genuine Streamlight replacement batteries.

4.3 Skladování

Uchovávejte svítilnu na chladném a suchém místě mimo přímé sluneční světlo a extrémní teploty.

5. Řešení problémů

Běžné problémy a jejich řešení naleznete v tabulce níže.

ProblémMožná příčinaŘešení
Svítilna se nezapne.Battery is depleted or improperly installed.Recharge the battery. Check battery orientation. Ensure tail cap is tightened.
Světlo je tlumené nebo bliká.Low battery charge. Loose connections.Recharge the battery. Ensure tail cap is tightened. Clean charging contacts.
Svítilna se nenabíjí.Charger not powered. Dirty charging contacts. Faulty battery or charger.Check power outlet. Clean charging contacts on flashlight and charger. Try a different power source. Contact customer support if issue persists.

6. Specifikace

FunkceDetail
ModelStinger LED HL 120/DC PB
Světelný zdrojLED
Bílý jas800 lumenů (vysoký)
Zdroj napájeníNapájení z baterie
Typ baterieNiMH (nikl-metalhydrid)
Počet baterií1 (součástí balení)
MateriálHliník, kov
BarvaModrý
Speciální funkceRechargeable, Multiple lighting modes (High, Medium, Low, Strobe)
Úroveň odolnosti proti voděNení odolný vůči vodě
Hmotnost položky3 libry

7. Informace o záruce

Streamlight products are known for their quality and durability. For specific warranty details, including coverage period and terms, please refer to the official Streamlight webwebu nebo záruční kartu, která byla přiložena k vašemu nákupu. Uschovejte si doklad o koupi pro případ reklamace.

8. Zákaznická podpora

If you have any questions, require technical assistance, or need to report an issue that cannot be resolved using the troubleshooting guide, please contact Streamlight customer support. Visit the official Streamlight website for contact information, including phone numbers and email addresses.

© 2026 Streamlight. All rights reserved. Streamlight and Stinger are registered trademarks of Streamlight, Inc.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.