HERTZ DS-303
HERTZ Dieci Series DS-303 12-inch Subwoofer Instruction Manual
Model: DS-303
Zavedení
Thank you for choosing the HERTZ Dieci Series DS-303 Subwoofer. This manual provides essential information for the proper installation, operation, and maintenance of your subwoofer. Please read this manual thoroughly before installation and use to ensure optimal performance and longevity of your product.
The HERTZ Dieci Series DS-303 is a 12-inch (300mm) car audio subwoofer designed for high efficiency and exceptional power handling. It features a polypropylene membrane and butyl rubber surround for high excursion with minimal distortion. An efficient cooling system ensures optimal heat dissipation. This subwoofer is suitable for use in compact sealed or reflex enclosures.
Bezpečnostní informace
Vždy dodržujte následující bezpečnostní opatření:
- Disconnect the vehicle's battery negative terminal before starting any installation work to prevent electrical shorts.
- Ujistěte se, že veškeré kabely jsou řádně izolovány a zajištěny, aby nedošlo k poškození vibracemi nebo ostrými hranami.
- Do not install the subwoofer in locations that obstruct the driver's view or interfere with vehicle safety systems (e.g., airbags).
- Pro připojení napájení a reproduktorů použijte kabeláž s odpovídajícím průřezem, aby bylo možné zvládnout napájecí požadavky subwooferu.
- Avoid exposing the subwoofer to excessive moisture or direct sunlight.
- Pokud si nejste jisti některou částí instalačního procesu, poraďte se s profesionálním instalatérem.
Co je v krabici
Po vybalení se prosím ujistěte, že jsou přítomny všechny položky:
- HERTZ Dieci Series DS-303 Subwoofer
- Návod k použití (tento dokument)
- Mounting Screws (if included by manufacturer)
Note: Additional accessories such as speaker wire, amplifier, and enclosure are sold separately.
Nastavení a instalace
Proper installation is crucial for optimal performance. This section outlines general guidelines. Specific enclosure design and wiring diagrams may vary based on your vehicle and ampnastavení zvlhčovače.
1. Enclosure Selection and Preparation
The DS-303 subwoofer is designed for use in compact sealed or reflex (vented) enclosures. Refer to the subwoofer's specifications for recommended enclosure volumes.

Obrázek: Zadní view of the HERTZ Dieci Series DS-303 Subwoofer, displaying the magnet structure and wiring terminals.
- Ensure the enclosure is robust and free from air leaks.
- Cut a circular opening in the enclosure baffle that matches the subwoofer's mounting diameter.
- Pre-drill pilot holes for the mounting screws to prevent damage to the enclosure or subwoofer frame.
2. Připojení vodičů
The DS-303 features a 4-Ohm Single Voice Coil (SVC). Connect the subwoofer to a compatible ampživější výstup.

Obrázek: Přední strana view of the HERTZ Dieci Series DS-303 Subwoofer, highlighting the polypropylene cone.
- Připojte kladný (+) pól subwooferu ke kladnému (+) pólu ampvýstup subwooferu zařízení Liferier.
- Připojte záporný (-) pól subwooferu k zápornému (-) pólu ampvýstup subwooferu zařízení Liferier.
- Ujistěte se, že všechna připojení jsou bezpečná a bez zkratů.
- Use appropriate gauge speaker wire for the power handling of the subwoofer and the distance to the ampživější.
3. Montáž subwooferu

Obrázek: Úhlový view of the HERTZ Dieci Series DS-303 Subwoofer, showing the robust frame and mounting holes.
- Carefully place the subwoofer into the prepared opening in the enclosure.
- Align the mounting holes on the subwoofer frame with the pre-drilled holes in the enclosure.
- Secure the subwoofer using the provided mounting screws. Tighten screws evenly in a crisscross pattern to ensure a tight, even seal. Do not overtighten.
Návod k obsluze
Once installed, follow these steps to operate your HERTZ DS-303 Subwoofer:
- Počáteční zapnutí: Po provedení a ověření všech připojení znovu připojte baterii vozidla. Zapněte autorádio.
- AmpNastavení čističky: Upravte zesílení, dělicí frekvenci a fázi na vašem amplifier according to your system's requirements and personal preference. Start with low gain and gradually increase.
- Doba záběhu: Allow a break-in period of approximately 10-20 hours of normal listening at moderate volumes. This allows the subwoofer's suspension components to loosen and achieve optimal performance.
- Ovládání hlasitosti: Avoid operating the subwoofer at excessively high volumes for extended periods, as this can lead to overheating and damage. If you hear distortion, reduce the volume immediately.
Údržba
The HERTZ DS-303 Subwoofer requires minimal maintenance to ensure long-lasting performance:
- Čištění: Kužel a jeho obvod jemně otřete měkkým, suchým hadříkem. Nepoužívejte agresivní chemikálie ani abrazivní čisticí prostředky.
- Inspekce: Pravidelně kontrolujte subwoofer, zda nevykazuje známky poškození membrány, obvodového pláště nebo krytky proti prachu. Zkontrolujte, zda jsou kabeláž pevná a zda neprůhledná.
- Ochrana životního prostředí: Keep the subwoofer free from dust, debris, and extreme temperatures.
Odstraňování problémů
Pokud máte problémy se subwooferem, podívejte se na následující běžné problémy a jejich řešení:
| Problém | Možná příčina | Řešení |
|---|---|---|
| Žádný zvuk ze subwooferu |
|
|
| Zkreslené nebo nejasné basy |
|
|
| Subwoofer gets hot |
|
|
If the problem persists after trying these solutions, contact HERTZ customer support or a qualified car audio technician.
Technické specifikace
| Funkce | Specifikace |
|---|---|
| Model | DS-303 |
| Velikost | 300 mm (12 palce) |
| Manipulace s výkonem (špička) | 1000 W |
| Power Handling (Continuous RMS) | 250 W |
| Impedance | 4 Ω (Ohm) |
| Frekvenční odezva | 28 • 300 XNUMX Hz |
| Citlivost | 91 dB SPL |
| Průměr kmitací cívky | 38 mm (1.5 palce) |
| Materiál magnetu | Ferit s vysokou hustotou |
| Kuželový materiál | Polypropylene with Mica injection |
| Surround materiál | Butylkaučuk |
| Xmax (maximální lineární exkurze) | 9 mm |
| Hmotnost položky | 8.8 liber (4 kg) |
| Technologie připojení | Kabelové |
| Výrobce | Electtromedia |
Informace o záruce
The HERTZ Dieci Series DS-303 Subwoofer comes with a Limited Warranty. Please refer to the warranty card included with your product or visit the official HERTZ website for detailed terms and conditions. This warranty typically covers manufacturing defects for a specified period from the date of purchase.
Note: Damage caused by improper installation, abuse, accident, or unauthorized modifications is not covered under warranty.
Zákaznická podpora
For technical assistance, troubleshooting beyond this manual, or warranty inquiries, please contact HERTZ customer support:
- Webmísto: www.hertzaudio.com
- E-mail: Obraťte se na úředníka webstránky s kontaktními formuláři nebo e-mailovými adresami.
- Telefon: Obraťte se na úředníka webmísto pro regionální kontaktní čísla.
When contacting support, please have your product model (DS-303) and proof of purchase readily available.
Ask a question about this manual
Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.