Kyosho Piper Cherokee Readyset Instruction Manual

1. Úvod

Děkuji za nákupasing the Kyosho Piper Cherokee Readyset. This manual provides essential information for the safe assembly, operation, and maintenance of your 1/24 scale remote-controlled aircraft. Please read this manual thoroughly before operating the model to ensure proper function and longevity.

2. Bezpečnostní informace

Operating remote-controlled aircraft requires caution. Failure to follow safety guidelines can result in injury or damage to property. Always observe the following:

• Pracujte v otevřeném prostoru, mimo dosah lidí, zvířat a překážek.
• Nelétejte v blízkosti elektrického vedení, silnic nebo vodních ploch.
• Před každým letem se ujistěte, že jsou baterie plně nabité.
• Vždy nejdříve zapněte vysílač a poté dron. Nejdříve vypněte dron a poté vysílač.
• Inspect the aircraft for damage before and after each flight.
• Keep fingers and loose clothing away from propellers.
• U mladších obsluh se doporučuje dohled dospělé osoby.

3. Obsah balení

Verify that all components are present in your Kyosho Piper Cherokee Readyset package:

• Piper Cherokee aircraft (pre-assembled)
• PERFEX KT-20 2.4GHz 4-channel MINIUM AD Special R/C System transmitter
• Flight battery (pre-installed or separate)
• USB charger (if included)
• Návod k použití (tento dokument)

Požadované pro provoz (není součástí balení):

• 4 "AA" alkaline batteries for the transmitter

4. Nastavení

4.1 Instalace baterie vysílače

1. Open the battery compartment cover on the back of the PERFEX KT-20 transmitter.
2. Insert four (4) "AA" alkaline batteries, ensuring correct polarity (+/-).
3. Bezpečně zavřete kryt bateriového prostoru.

4.2 Nabíjení letecké baterie

The flight battery requires charging before first use. A full charge takes approximately 20 minutes.

1. Connect the flight battery to the provided charger.
2. Connect the charger to a suitable power source (e.g., USB port).
3. Observe the charger's indicator light (refer to charger manual for specific light patterns).
4. Disconnect the battery once charging is complete. Do not overcharge.

4.3 Binding (Pairing) the Transmitter and Aircraft

Your Readyset aircraft and transmitter are typically pre-bound from the factory. If re-binding is necessary, follow these general steps:

1. Ensure the transmitter batteries are installed and the transmitter is OFF.
2. Připojte letovou baterii k letadlu.
3. Turn ON the transmitter while holding the bind button (if present, refer to transmitter manual).
4. The aircraft's receiver light should indicate a successful bind (e.g., solid light).
5. Turn off both the aircraft and transmitter, then power them on in the correct sequence (transmitter first, then aircraft) to confirm binding.

Figure 1: The Kyosho Piper Cherokee Readyset, available in red or blue color schemes. This image displays the compact size and design of the remote-controlled aircraft, highlighting its wingspan and overall structure.

5. Návod k obsluze

5.1 Předletové kontroly

• Ensure all control surfaces (ailerons, elevator, rudder) move freely and correctly in response to transmitter inputs.
• Check propeller for damage and ensure it is securely attached.
• Verify flight battery is fully charged and securely installed.
• Confirm transmitter batteries have sufficient power.
• Check weather conditions; avoid flying in strong winds or rain.

5.2 Vzlet

For hand-launching:

1. Hold the aircraft firmly with one hand, away from the propeller.
2. Apply full throttle with the transmitter.
3. Gently toss the aircraft forward and slightly upwards into the wind.
4. Immediately gain altitude and establish stable flight.

5.3 Řízení letu

The PERFEX KT-20 2.4GHz 4-channel system provides control over:

• Škrticí klapka: Řídí rychlost motoru a nadmořskou výšku.
• Výtah: Ovládá výšku tónu (nos nahoru/dolů).
• Křidélka: Controls roll (wing tilt for turns).
• Kormidlo: Ovládá stáčení (nos vlevo/vpravo).

Practice gentle control inputs, especially during initial flights, to familiarize yourself with the aircraft's response.

5.4 Přistání

1. Approach the landing area into the wind.
2. Gradually reduce throttle and maintain a controlled descent.
3. Use elevator to flare (gently raise the nose) just before touchdown to reduce speed and achieve a soft landing.
4. Cut throttle completely upon touchdown.

6. Údržba

Regular maintenance ensures optimal performance and extends the lifespan of your Piper Cherokee.

• Čištění: Po každém letu otřete letadlo měkkým, suchým hadříkem, abyste odstranili nečistoty a úlomky.
• Vrtule: Inspect the propeller for cracks or damage. Replace if necessary.
• Řídicí plochy: Check hinges and linkages for wear or looseness. Ensure smooth movement.
• Péče o baterie: Store flight batteries at a partial charge (around 3.8V per cell for LiPo) if not used for extended periods. Do not store fully charged or fully discharged.
• Skladování: Letadlo skladujte na chladném a suchém místě, mimo dosah přímého slunečního záření a extrémních teplot.

7. Řešení problémů

8. Specifikace

9. Záruka a podpora

For warranty information and technical support, please refer to the official Kyosho website or contact Kyosho customer service directly. Specific warranty terms and conditions may vary by region and purchase date. Keep your proof of purchase for any warranty claims.

Kyosho Contact Information: Prosím navštivte www.kyosho.com pro nejaktuálnější zdroje podpory a kontaktní údaje.