Elkay LK35B

Elkay LK35B 3-1/2" Drain Fitting Instruction Manual

Model: LK35B

1. Úvod

This manual provides detailed instructions for the installation, operation, and maintenance of your Elkay LK35B 3-1/2" Drain Fitting. This drain fitting is designed for kitchen sinks and features a durable Type 304 stainless steel body, a strainer basket, and a tailpiece, ensuring long-lasting performance and resistance to corrosion.

2. Bezpečnostní informace

  • Během instalace vždy používejte vhodné osobní ochranné prostředky (OOP), jako jsou ochranné brýle a rukavice.
  • Ensure the water supply to the sink is turned off before beginning installation to prevent leaks.
  • Handle all components carefully to avoid injury or damage to the product.
  • Pokud si nejste jisti některým krokem, poraďte se s kvalifikovaným instalatérem.
  • Udržujte malé části mimo dosah dětí.

3. Obsah balení

Před zahájením instalace ověřte, zda jsou všechny komponenty přítomny:

  • 3-1/2" Drain Fitting (Type 304 Stainless Steel Body)
  • Sítko koš
  • Koncovka
  • Mounting Hardware (gaskets, nuts, washers)

4. Nastavení a instalace

Follow these steps to properly install your Elkay LK35B drain fitting. Basic plumbing tools such as a wrench, plumber's putty, and a screwdriver may be required.

4.1 Příprava

  1. Vypněte přívod vody do dřezu.
  2. If replacing an old drain, remove it and clean the sink drain opening thoroughly.
  3. Apply a thin bead of plumber's putty around the underside of the drain fitting's flange.

4.2 kroky instalace

  1. Insert the drain fitting flange into the sink drain opening from the top. Press firmly to create a seal with the plumber's putty.
  2. From underneath the sink, slide the rubber gasket, then the friction washer, and finally the locknut onto the drain fitting's threaded body.
  3. Tighten the locknut by hand, then use a wrench to secure it firmly. Do not overtighten, as this can damage the sink or fitting.
  4. Attach the tailpiece to the bottom of the drain fitting using the provided slip nut and washer. Ensure a tight seal.
  5. Connect the tailpiece to your existing P-trap assembly.
  6. Wipe away any excess plumber's putty from around the drain opening.
Elkay LK35B 3-1/2 inch Drain Fitting components

Figure 1: Elkay LK35B 3-1/2 inch Drain Fitting with its components, including the stainless steel body, strainer basket, and tailpiece, ready for installation.

4.3 Kontrola po instalaci

  1. Turn on the water supply and fill the sink with water.
  2. Remove the strainer basket and open the drain.
  3. Carefully inspect all connections under the sink for any leaks. Tighten connections as needed.

5. Návod k obsluze

The Elkay LK35B drain fitting is designed for simple operation:

  • Sítko: Place the strainer basket into the drain opening to catch food particles and debris, preventing clogs in your plumbing.
  • Vypouštění: To drain water from the sink, simply lift the strainer basket.
  • Stopping Water: The strainer basket can also be pressed down to create a seal, allowing the sink to hold water. Ensure the basket is clean for an effective seal.

6. Údržba

Regular cleaning and maintenance will ensure the longevity and optimal performance of your drain fitting.

  • Denní úklid: Remove the strainer basket and empty any collected debris. Rinse the basket and the drain opening with warm water.
  • Hloubkové čištění: For a more thorough clean, use a mild dish soap and a soft cloth or sponge. Avoid abrasive cleaners, scouring pads, or harsh chemicals, as these can scratch the stainless steel finish.
  • Prevence skvrn: Wipe down the drain fitting after use to prevent water spots and mineral buildup, especially in hard water areas.
  • Odolnost proti korozi: The Type 304 stainless steel is highly resistant to corrosion. However, prolonged exposure to strong acids or bleach should be avoided.

7. Řešení problémů

ProblémMožná příčinaŘešení
Leakage around the drain flangeImproperly applied plumber's putty or loose locknut.Ensure plumber's putty is evenly applied. Tighten the locknut underneath the sink. If leakage persists, remove, reapply putty, and reinstall.
Leakage at tailpiece connectionLoose slip nut or worn washer.Tighten the slip nut. Replace the washer if it appears worn or damaged.
Pomalé odváděníStrainer basket clogged with debris or P-trap blockage.Remove and clean the strainer basket. Check the P-trap for blockages and clear if necessary.
Strainer basket does not seal properlyDebris under the basket or worn rubber seal on the basket.Clean the underside of the strainer basket and the drain opening. Replace the strainer basket if the seal is damaged.

8. Specifikace

FunkceDetail
Číslo modeluLK35B
Velikost odtoku3-1/2 palce
MateriálNerezová ocel typu 304
KomponentyBody, Strainer Basket, Tailpiece
Hmotnost položky1.04 libry
Rozměry produktu4.4 x 4.4 x 7.3 palce
DokončitNerez

9. Záruka a podpora

Elkay products are manufactured to high-quality standards. For specific warranty information, please refer to the warranty card included with your purchase or visit the official Elkay website. For technical support or assistance, please contact Elkay customer service through their official channels.

Elkay Customer Service: www.elkay.com/us/en/support.html

© 2023 Elkay. All rights reserved. This manual is for informational purposes only.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.