Zavedení
This manual provides essential information for the safe and proper installation, operation, and maintenance of your Leviton Commercial Grade Single Receptacle Outlet, Model 5821-W. This 20 Amp, 250 Volt, NEMA 6-20R, 2-Pole, 3-Wire receptacle is designed for commercial and institutional applications, offering durability and reliable performance. Please read all instructions carefully before beginning installation.
Důležité bezpečnostní informace
VAROVÁNÍ: Nebezpečí úrazu elektrickým proudem nebo požáru.
- Always turn off power at the circuit breaker or fuse box before installing or servicing this device.
- Instalaci musí provést kvalifikovaný elektrikář v souladu se všemi národními a místními elektrotechnickými předpisy.
- Use only copper or copper-clad wire. Do not use with aluminum wiring.
- Ujistěte se, že všechna vodičová spojení jsou bezpečná a řádně izolovaná.
- Do not exceed the specified electrical ratings of 20 Ampa 250 voltů.
- Toto zařízení je určeno pouze pro vnitřní použití.
Failure to follow these instructions may result in serious injury, death, or property damage.
Konec produktuview
The Leviton 5821-W is a commercial specification grade single receptacle outlet. It features a smooth face and is designed for side wiring. The NEMA 6-20R configuration indicates it is a 2-pole, 3-wire grounding receptacle rated for 20 Amps na 250 voltů.
Obrázek 1: Přední strana view of the Leviton 5821-W Single Receptacle Outlet, showing the NEMA 6-20R configuration.
Obrázek 2: Strana view of the Leviton 5821-W Single Receptacle Outlet, highlighting the side wire terminals.
Obrázek 3: Zpět view of the Leviton 5821-W Single Receptacle Outlet, showing the robust construction and wiring access points.
Nastavení a instalace
Požadované nástroje: Screwdriver (Phillips and flathead), Wire Strippers, Electrical Tape, Voltage Tester.
- Vypnout napájení: Vyhledejte jistič nebo pojistku, která ovládá zásuvku, kterou vyměňujete nebo instalujete. Vypněte ji. Ověřte, zda je napájení vypnuto pomocí regulátoru hlasitosti.tage tester.
- Remove Old Receptacle (if applicable): Unscrew the wall plate and then the mounting screws holding the old receptacle in the electrical box. Carefully pull the old receptacle out of the box. Disconnect the wires, noting which wire was connected to which terminal.
- Připravte dráty: Strip approximately 1/2 inch (12.7 mm) of insulation from the ends of the circuit wires. Ensure the wire ends are clean and straight.
- Připojit dráty: The Leviton 5821-W is a side-wire only device.
- Připojte ČERNÝ or ČERVENÝ (hot) wire to the MOSAZ terminal screw.
- Připojte BÍLÝ (neutral) wire to the STŘÍBRO terminal screw.
- Připojte ZELENÝ or bare copper (ground) wire to the ZELENÝ terminal screw.
- Montážní zásuvka: Carefully fold the wires into the electrical box, leaving enough room for the receptacle. Insert the receptacle into the box and secure it with the mounting screws.
- Instalace nástěnné desky: Attach the wall plate over the receptacle and secure it with the provided screw(s).
- Obnovit napájení: Znovu zapněte napájení jističem nebo pojistkovou skříňkou.
- Test: Verify the receptacle is functioning correctly with a suitable device.
Návod k obsluze
The Leviton 5821-W Single Receptacle Outlet operates by providing a 20 Amp, 250 Volt power connection for compatible NEMA 6-20P plugs. Simply insert the plug of your electrical device into the receptacle. Ensure the plug is fully inserted for a secure connection.
This receptacle is designed for continuous duty within its specified ratings. It does not feature any user-operable controls or indicators.
Údržba
The Leviton 5821-W receptacle requires minimal maintenance. Regular inspection and cleaning are recommended to ensure optimal performance and safety.
- Čištění: To clean the surface of the receptacle, first turn off power at the circuit breaker. Use a soft, damp cloth with a mild detergent. Do not use abrasive cleaners or solvents. Ensure the surface is completely dry before restoring power.
- Inspekce: Periodically inspect the receptacle for any signs of damage, such as cracks, discoloration, or loose connections. If any damage is observed, turn off power immediately and have the receptacle inspected and replaced by a qualified electrician.
- Těsnost: Over time, wire connections can loosen. If you suspect a loose connection (e.g., flickering power, heat from the outlet), turn off power and have a qualified electrician check and tighten all terminal screws.
Odstraňování problémů
If you experience issues with your Leviton 5821-W receptacle, refer to the following common troubleshooting steps. Always ensure power is OFF before performing any inspection or repair.
| Problém | Možná příčina | Řešení |
|---|---|---|
| Žádné napájení v zásuvce. | Circuit breaker tripped or fuse blown. Loose wiring connection. Faulty receptacle. | Check and reset the circuit breaker or replace the fuse. Turn off power and check wire connections; tighten if loose. If problem persists, replace the receptacle. |
| Plug does not fit or is loose. | Incorrect plug type (not NEMA 6-20P). Worn receptacle contacts. | Ensure the device plug is NEMA 6-20P. If contacts are worn, replace the receptacle. |
| Nádoba je teplá na dotek. | Overload. Loose wiring connection. | Reduce the load on the circuit. Turn off power and check wire connections; tighten if loose. If warmth persists, consult a qualified electrician. |
If troubleshooting steps do not resolve the issue, contact a qualified electrician for assistance.
Specifikace
| Funkce | Detail |
|---|---|
| Značka | Leviton |
| Model | 5821-Z |
| Typ | Zásuvka s jednou zásuvkou |
| Stupeň | Commercial Specification Grade |
| Ampvymazat | 20 Amps |
| svtage | 250 voltů |
| Konfigurace NEMA | 6-20R |
| Tyče/dráty | 2-Pole, 3-Wire Grounding |
| Způsob zapojení | Side Wire Only |
| Materiál | Nylon |
| Barva | Bílý |
| Rozměry produktu | 12.5"L x 8"W (Note: This dimension seems unusually large for an outlet. It might refer to packaging or a different measurement. Actual device dimensions are typically smaller.) |
| Certifikace | UL Listed 498, CSA Certified, NOM Certified, Meets NEMA WD-1 and WD-6, ANSI Standards |
| UPC | 078477790281 |
Záruka a podpora
Záruka: This Leviton product is backed by a limited 10-year warranty on parts. For specific terms and conditions, please refer to the warranty documentation included with your purchase or visit the official Leviton webmísto.
Zákaznická podpora: For technical assistance, product inquiries, or warranty claims, please contact Leviton customer support through their official website or the contact information provided in your product packaging. Always provide the model number (5821-W) when seeking support.
You can visit the official Leviton store for more information: Leviton Store
